You are here:
Forums
Pickups
Dodge Ram
Dodge Ram Cummins Diesel Questions

642 messages, Last post on Nov 12, 2009 at 5:22 AM
You are in the Dodge Ram Forum. Your Host is kcram
|
Replying to: denver2 (Aug 20, 2008 9:15 am) When I am on a trip I always keep my exhaust brake on. nice to let off the gas if you see a highway patrol and the truck just slows down without hitting the brakes. hope, this helps. They are awesome trucks, but are truly made to work! |
|
|
Replying to: fordfan08 (Sep 24, 2008 7:22 am) I have two of these new blue tec's and I have not had any trouble with them. Both are manual's. However, they are both on the highway a lot and both pull trailers. A majority of the problems people are facing is that they are not getting them hot enough to keep all the equipment cleaned out. They will plug up if you idle them a lot or just run them around town. These trucks need to work! I have edge chips and large air box's on both of them. I can get around 18mpg empty and about 12-14 pulling 15,000lbs. |
|
|
I have a 01 dodge 2500 diesel cummins I got a code P0251 stating that Injection pump fuel metering control "A" malfunction, does anyone know what that it's. thanks rico |
|
| I have a Ram 2500 when turn the key switch on the check engine light and the generator light come on wait 5 to 10 sec I get a click and the gen light goes out truck won't start without giving it a little go peddle it will idle but if I put it in drive it stalls but in reverse it will run. Any ideas? | |
will the computer work from my 03 ram diesel into my 05...they both have sentry key system.
|
|
|
Replying to: pwb1 (Oct 30, 2008 1:56 pm) kcram - Pickups Host |
|
| Today, I had to stop short in traffic in my 02 2500 cummins powered ram, and stalled out. When I reset the ignition to restart, I got no warning bells until I had cranked for several seconds, Now, I get the warning bells, but still wont restart, and the bells chime in again after cranking for about 5-10 seconds. Engine light is on. Any help would be hugely appreciated. Thanks | |
|
|
| I have an early '97 Dodge 2500 Cummins that recently decided not to start. Actually it will start and rev up but will not run. It dies quickly like it's not getting fuel, but then it will have enough fuel to start and rev up again before dying. Is the lift pump the most likely culprit here or could it be something else? | |
| when I start the truck for the first time of the day it cuts out when taking of for the first mile or two then it runs like it should once warmed up . Anyone got ideas what it might be? | |
| I have recently changed my fuel filter on this truck and then about a week later I ran it to empty (oops). Now for no reason when running at a slow speed or coming to a stop the truck will stall. I get no warning lights it just stalls or sometimes it will run great and then I park it for work after work go to start it and it wont start, next day starts fine. Any suggestions? | |
You are here:
Forums
Pickups
Dodge Ram
Dodge Ram Cummins Diesel Questions
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2010 Dodge Ram Pickup 2500
2010 Dodge Ram Pickup 3500



Browse by Board
Browse by Topic