Edmunds.com | Inside Line | Auto Observer Your Account | Help | Directory
You are here:
![[F]](http://a332.g.akamai.net/f/332/936/12h/www.edmunds.com/media/townhall/webxicons/site.gif){kind=small}
Forums
SUVs Kia Sportage Kia Sportage Maintenance and Repair
608 messages, Last post on Nov 28, 2009 at 4:25 PM
You are in the Kia Sportage Forum. Your Hosts are steve_ & tidester
|
Replying to: tcolburn (Apr 07, 2008 7:08 am) Pull passenger witch, disconnect wire bundle, check for solid ground contact at 3 and 6 of wire bundle. If one fails, problem is with driver switch. ...
|
|
The injectors have no signal. The garage put a new fuel pump in it,no change. They put a different computer in it,no change. Checked fuses and relays, all seem ok. Any help email me jluce74 hotmail.com Thanks,Jason
|
|
| Hi all i had wrote a post sometime ago about how my headlights,dashlights (also the lights around the gas and temp guage work whentey want) and domelight all flicker when i drive my car. I was just wonderinig if anyone has had the same problem and if so how did you correct it? Any help would be great. | |
|
Replying to: ort102 (Feb 02, 2008 8:18 pm) 
|
|
|
Replying to: jhl1 (Apr 11, 2008 7:35 pm) Check cam sensor connector, ground, +12V with key ON on all injectors green wire. 
|
|
|
Replying to: lmp4 (Apr 14, 2008 4:03 am)
|
|
|
Replying to: jhl1 (Apr 14, 2008 5:03 pm) ??? you mean on the green wire of the injectors?...THis should be dead with key off.... At this time, I have personnally had no problem of that type,. so this info is strictly based on the diagrams. Some measurements can lead to confusion as measuring voltage on a disconnected socket without any load can measure a stray voltage, specially with electronics, that would collapse as soon as a load is connected. So I suggest you make a connection on one of the green wires, and use it to feed a test lamp, the other side of the lamp to ground, then try key ON and OFF. YOu can use a spare parking bulb as a test light, not a stop lamp as their current is much larger and the injector drivers are designed for just 1 amp.
|
|
|
Replying to: lmp4 (Apr 15, 2008 1:40 pm)
|
|
|
Replying to: jhl1 (Apr 15, 2008 6:01 pm) UNplug the MAIN relay for a test or pull out MAIN fuse out; and check those diagrams...specific to 2001 (the former one was 2000, most similar except BK/W wire ..... Black/white is feed to idle air control motor and should also be OFF with key off. +12V to injectors and dile control comes from the main relay, not the F.P. relay. But if MAIN relay is frozen ON, then the F.P. relay will also be ON all the time. Since you have another relay available, replace the MAIN relay for a test. Someone had a quite similar problem recently on this or another forum, However this condition as such would not stop the car from starting....but it would drain the battery if car was left alone for some time. http://i250.photobucket.com/albums/gg246/avigex/relays2001.gif http://i250.photobucket.com/albums/gg246/avigex/injectors2001.gif CHeck under the seat for traces of water to the computer. The MAIN relay always has 12V on one side of its coil, and the other side of coil is grounded at KEY ON by the computer (located lower right side trim panel below the instrument panel, on the passenger side of the vehicle).
|
|
|
Replying to: lmp4 (Apr 16, 2008 4:43 am)
|
|
You are here:
Forums
SUVs Kia Sportage Kia Sportage Maintenance and Repair
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2009 Kia Sportage
Browse by Board
Browse by Topic
Today's Chats
