You are here:
Forums
SUVs
Jeep Cherokee and Jeep Grand Cherokee
Jeep Cherokee XJ Mods

10 messages, Last post on Jun 19, 2009 at 12:00 PM
You are in the Jeep Cherokee and Jeep Grand Cherokee Forum. Your Hosts are steve_ & tidester
|
Replying to: fingal (Jul 26, 2006 12:26 am) Of course u want more power out of the 4.0L, the low end is great, but the mids could be better, i think the new Edge products, Trail Jammer pkg. is the best bang for the buck, and if you use the Flowmaster w/ that, w/ maybe 3.0" out the back, or Dual exhaust, i think it would make a great combo. Rockcrawler.com, just did a test on it. check it out.......hope i helpd. peace |
|
|
Replying to: fingal (Jul 30, 2006 7:34 pm) If it's leaking out the TOP of the cylinder head, then it will be the valve cover gasket. They are known to leak. |
|
| tou will need to add a steering stabilizer i would put a throtle body spacer a k and n filter kit it will give you more horse power you will put alot of stress on the axles with the tires your best bet is to find dana 44 for front and rear you can ues the ones off a f250 truck but you have to change the spring mounts but if you dont change the axles you can espect to have trouble later with those tires i would put 33-12-50 they will not put as much stress on the axles if your going to climb hills then i would find some lockers for front and rear.you can also find a wrecked rubicon they have dana 44s and lockers from the factory. and they will bolt up you wont need longer drive shaft your factory should have about 3 inches of play i would get quick disconect sway bars for when you want to flex out a little. and some good advice is to have the exhaust ran above the skid plate under the transfer case. | |
|
|
|
Replying to: fingal (Jul 26, 2006 12:26 am) |
|
|
Hey Jeep experts! Looking for some advice here. Have a 98' Jeep Cherokee Sport 4x4, 4.0L I-6, 5 Spd Manual. I am very happy with this as our family vehicle. It'smostly driven on road, except for occasional camping trips towing small boat for long highway rides, then some offroading when we get there, just to get the boat into the lake. Situation: I don't really care for the stock rims and have just purchosed a set from a 2008 Rubicon, (I think). I have always liked these newer rims but unfortunately the bolt pattern is different, (5x5 instead of stock 4.5x5). The obvious and only solution is to buy wheel adaptors which I intend to to. Now, I do not want low profile tires, but the correct tires for these 17" rims will surely demand more space or else I could probably expect rubbing problems, etc. Do I need to lift my Jeep, or can I get away with just modifying the fender flares?Also, as I was looking into flare kits I noticed that they all say they fit up to '96 XJ's. Will these kits fit a '98? I do realize that some trimming will be necessary for some flare kits. I need advice on a good 17" wheel tire size that will work without turning our family car into a "Monster Truck" as this vehicle is intended mostly for an road use. Tire size on 17" rims? flare kit? Triming involved? To lift, or not to lift? I am imagining a combo like, 4in lift, 31 in tires, trim fenders and install flares. But I think I need advice from the experts brfore begining any mods if some can be avoided, keeping in mind I want to avoid road handling problems, or having a hard time lifting kids into child seats, but want to make these rims work without rubbing, etc. I will appreciate any advice or recomendations. Thanx RJRacer |
|
|
|
|
Replying to: fingal (Jul 26, 2006 12:26 am) 179,000 miles and still going. |
|
You are here:
Forums
SUVs
Jeep Cherokee and Jeep Grand Cherokee
Jeep Cherokee XJ Mods
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2001 Jeep Cherokee



Browse by Board
Browse by Topic
Today's Chats