You are here:
Forums
Vans & Minivans
Chrysler Town & Country/Dodge Grand Caravan
Caravan/Town & Country Electrical Problems

379 messages, Last post on Nov 19, 2009 at 6:13 PM
You are in the Chrysler Town & Country/Dodge Grand Caravan Forum. Your Host is Karens
|
|
|---|---|
|
Replying to: b42l8 (Mar 18, 2009 2:59 pm) |
|
|
|
| We have 04 Town & Country and it won't start. All systems seem fine - checked cables/cable track of doors. Antitheft light is on. Resodered instrument circuit board as was suggested in some of the answers. No change. Could it be the key code lost out of control module? Can you disable antitheft feature or wire around it? | |
|
Replying to: chrytech1 (Feb 16, 2008 5:11 am)
|
|
|
Replying to: rtreet (Mar 30, 2009 10:35 am) - not working instrument cluster, all the gauges at zero, no display for distance or trip - not working wiper intermittent - not working speed control (tempomat) - when loocking the doors it unlock imediately But, sometimes when driving, the instrument cluster start working. I have already check the fuses, relays, conectors, remove the BCM and reinstal, resolder conector on instrument cluster panel, put the ground (-) wire direct to pin 7 on instrument cluster conector because I do not found the ground G200. Disconect clockspring conector, disconect conector on HVAC. Any idea?
|
|
|
Replying to: ringalori (Apr 07, 2009 5:18 am) |
|
i have a 98 t&c the battery was going dead and the alarm was not reseting so i replaced the battery now all the buttons next to the ac controls are flashing. then after driving a while they stop. all the buttons still work. is there a reset for these? also i have had some issues lately with a random sputter. ill be driving and it will sputter sometimes and not others. ive checked for dtcs and there were none. i havent seen the ses light come on at all while this happens. i have had cluster issues where i had to hit the dash to get the car to start. i also have replaced the crank sensor and it helped for a while but now its back. thank you for your help
|
|
|
I started my town and country, and it was running rough. I replaced my plugs and wire, but still no change. I believe my alternator is going bad...will this make the van run rough?? I have the "engine" symbol lit on the dash too. thanks |
|
|
Replying to: dugger2 (May 17, 2009 10:54 am) You may have a vacuum or fuel supply problem that is causing the rough operation. Find out the code(s) in the system by using a reader - that may give you a good idea of where to start. In general, I would check my compression first, then spark quality (there could be a problem with the ignition coil), then go from there.
|
|
|
Replying to: xwesx (May 17, 2009 12:17 pm) I did pull the wires off one at a time at the ignition coil....and there were 2 that weren't sparking strong like the others I also disconnected the battery while the van was running...and the engine would die...and I hear a loud noise coming from he alternator area...so I do believe I have an alternator going bad too |
|
|
Replying to: dugger2 (May 17, 2009 10:54 am) |
|
You are here:
Forums
Vans & Minivans
Chrysler Town & Country/Dodge Grand Caravan
Caravan/Town & Country Electrical Problems
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2010 Chrysler Town and Country
2007 Dodge Caravan



Browse by Board
Browse by Topic
Today's Chats