You are here:
Forums
Vans & Minivans
Chrysler Town & Country/Dodge Grand Caravan
Caravan/Town & Country Electrical Problems

383 messages, Last post on Nov 30, 2009 at 1:11 PM
You are in the Chrysler Town & Country/Dodge Grand Caravan Forum. Your Host is Karens
|
Replying to: beaupied (Mar 20, 2008 8:56 am) Thanks.
|
|
|
Replying to: hollfam (Nov 03, 2008 10:33 am) |
|
|
i have a 1986 dodge caravan se the passenger side sliding door (manual type) door handle and internal guts busted on me the van only has 195856 miles on it. how can i fix this and where can i find diagrams of the complete mechanisim (blueprints) for it or any ideas where I can get the peice for this I need the inside handle including the lever(handle) spring the little bar grommets this is a dual locking mechanisim door; 2 locks which are as follows one catch on the front of the door and one on the rear of the door they both have to go towards the front of the van in order to open the sliding door; but the one on the rear pulls towards the front of the van and the one on the front of the sliding door pushes towards the front of the van to unlock it also I am needing to find out the specs of the driver side lock for the left door the door is extremely hard to shut and usually requires 3 or 4 times of slamming before the door will fully shut. does any one else out there have one of these older type of vans and have you had the smae problem(s) yet? if you did what did you do to correct the problem(s)? |
|
|
Replying to: kpegelow (Oct 26, 2008 7:04 pm) |
|
|
Replying to: rayfalcon (Nov 19, 2008 10:42 pm) |
|
| I have have a 1997 Chrysler T&C LXi. I have had previous problems where the vehicle would start for about 5 seconds and then shut down. After having it towed to the dealer where they found no problems, it started. After going through this a couple times I found that removing and replacing the gas cap would resolve the problem. Now a few years later with no problems my vehicle will not start. It starts for a second and shuts off. This time no gauges are working but the radio does, any thoughts? | |
|
Replying to: jmudry (Jul 18, 2006 4:03 am) Have you tried calling Chrysler's Customer Service yet? If not, you are in for a thrill. You'll get to talk to a lot of agents in India. If you are persistent enough, they'll transfer you to someone in the US. Good luck!!!!!! |
|
|
Replying to: rayfalcon (Nov 19, 2008 10:42 pm) and last but not least sawsall blades 1 blade abt $1.50. it roughly costs about $25.00 to make a handle asuming that you dont have to purchase any of the tools special for this project. not sure on the arc rods exactly how much they run they were my buddies he let me use his arc welder.thanks for all of you help guys and gals helpso far. God Bless you all ! P.s. if yall know how to upload pics please tell me how if you want to see the finished product btw I didnt go for prettiness just a working one. but i could dress it up and make it look better by the way in case any of you all want to email me instead of posting a response on here or to email me for pics here is my emai address truckinforjesus
|
|
|
Replying to: debspalmtree (Nov 01, 2007 4:08 pm) |
|
|
Replying to: rayfalcon (Nov 25, 2008 5:13 pm)
|
|
You are here:
Forums
Vans & Minivans
Chrysler Town & Country/Dodge Grand Caravan
Caravan/Town & Country Electrical Problems
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2010 Chrysler Town and Country
2007 Dodge Caravan



Browse by Board
Browse by Topic
Today's Chats