You are here:
Forums
Hatchbacks
Nissan Versa
Nissan Versa Accessories and Modifications

21 messages, Last post on Nov 25, 2009 at 3:54 AM
You are in the Nissan Versa Forum. Your Host is pf_flyer
|
|
|---|---|
|
It's pretty easy. Take a 6ft. section of a 1X10 and cut it into 3 equal pieces. Cut one piece in half to use for the ends. Screw (or nail) the pieces together. I use the shorter pieces on the inside. If you use them on the outside, you'll need to shorten the length wise pieces by two inches. I made two of these boxes so I can cover the whole cargo area when necessary or use just one when two aren't required. For transporting my mulch bins (42x21), two is better. For one bike, one is plenty. The best part of this open design is that I give up very little storage space in the cargo area. The wood can also be painted to match if aesthetics are important. David
|
|
|
|
|
Replying to: bikedorian (Jul 05, 2007 12:26 pm) Niels |
|
| Removing versa top dashboard panel seems not easy. Can anybody pass me the procedure to do so? I want to upgrade the two small vents on the top each side. | |
| Has anyone found an internet site with the parts to add Daytime running lights to a 2008 Versa 'S'? I believe DRL is standard on Canadian vehicles, so suspecting that that parts would be plug and play....if available anywhere. | |
|
|
|
Purchased the basic 2008 Versa Hatchback model, not thinking that not having power doors and windows would be a problem. Realized now that the door locks are a problem because it is difficult to reach from the drivers door into the rear doors to unlock. Trying to make up for this by having power locks installed on an alarm. Been to three alarm places and none have actuators that fit the car door. Each place said if I can get the actuator from Nissan, they will install. Called three Nissan dealers, not one of the parts departments can tell me what actuator Nissan sells that will fit this model. Has anyone done this and where did you go for the actuators? If you got them from Nissan, do you have a part number? |
|
| Gas cap is difficult to remove due to high vacuum. Dealer say's design problem. Until resolved , use wrench to remove. I ordered a" stant" gas cap for $15. that does not have to be removed . Just place pump nozzle thru both flappers and fill. Pump will shut off automatically, as before. No light on dash came on, so far. NEATO!. | |
|
|
|
Replying to: Sylvia (Jul 17, 2006 10:37 am)
|
|
|
Replying to: yndangerous (Oct 16, 2009 11:29 pm) So you might want to check into that before you proceed |
|
|
|
|
Replying to: shannyp20 (Nov 24, 2009 8:00 pm) |
|
You are here:
Forums
Hatchbacks
Nissan Versa
Nissan Versa Accessories and Modifications
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2010 Nissan Versa



Browse by Board
Browse by Topic