Ask the Car People.SM


Cruise Control

10 messages,  Last post on Oct 08, 2008 at 6:55 AM

You are in the Chevrolet Blazer Forum.

What is this discussion about? Chevrolet Blazer, Electrical, Truck

Messages Page 2 of 2

#3 of 10 Re: Cruise Control [nhomad] by repairdog

Jul 10, 2006 (5:54 pm)

Replying to: nhomad (Jul 10, 2006 2:56 am)
If it worked prior to the wiring install you have to think thats the problem - no, the computer does not have to reset for cruise. Did you buy the GM connector (all prewired back there) or splice in? Bet the cruise thinks the brake pedal (switch on the pedal arm) is depressed so cuts the cruise out. Check the new wiring and the rear connector - oh any trailer brakes on this so 7 not 4 pins?

#4 of 10 cruise control not working after replacing master combo switch assembly by catlover11381

Jul 19, 2006 (4:36 am)

I recently brought my Chevy Impala LS 2002 to have a problem with high beams and lights repaired. Combo switch assembly was replaced and now, my cruise control does not function. Mechanic said cruise worked when it was tested, there are no loose connections, etc. Never had a problem prior to this repair visit. I'm being told perhaps it's something in the dash not working . . . activation cruise control light no longer appears on dash. Any suggestions?

#6 of 10 Re: cruise control not working after replacing master combo switch assembly [catlover11381] by repairdog

Jul 19, 2006 (2:14 pm)

Replying to: catlover11381 (Jul 19, 2006 4:36 am)
Since when is this a Blazer - anyway he pulled the harness from the column so think its on him to correct - gee worked before but not after - have a discussion with the manager - also the brake pedal has a shutoff switch/brake light switch that may be involved/bad/disconnected - seen them activate the brake lights but were adjusted so far out that they deactivated the cruise. Check all fuses and all the connectors too. No light = no activation

#7 of 10 Silverado Cruise Control by gundoctor

Feb 20, 2007 (6:34 pm)

My cruise control works during the daytime, but when the lights come on (other than daylight driving lights) or I manually turn them on, my cruise control quits working in less than a minute. Cannot set the cruise control while lights are on. As soon as I turn the lights off, cruise will work again. Any ideas?

#8 of 10 Re: Silverado Cruise Control [gundoctor] by repairdog

Feb 20, 2007 (6:38 pm)

Replying to: gundoctor (Feb 20, 2007 6:34 pm)
Would look at a voltage drop in the circuit probably in the multifunction switch - look at the wiring in the column as the hi/low beam is in the MFS.

#9 of 10 cruise control and fuel efficiency by jmosby1469

Oct 06, 2008 (4:35 pm)

The conventional wisdom that the use of cruise control helps improve fuel economy, by evening out the accelerations and decelerations involved in usual driving practices, has a flaw. I notice that using this feature on roads with varying terrains, including many hills, results in my RPM's increasing sharply as my vehicle ascends these hills. I believe these sudden sharp increases in my engine's output negates many benefits to fuel economy of keeping the cruise control set. Your comments, please.

#10 of 10 Re: cruise control and fuel efficiency [jmosby1469] by jlflemmons

Oct 08, 2008 (6:55 am)

Replying to: jmosby1469 (Oct 06, 2008 4:35 pm)
You are correct. Cruise control is not effective for fuel economy in rolling terrain as it cannot "look ahead" and compensate. Nor can it "average" such as letting the car gain a few MPH leading up to a hill, or drop a few extra MPH while approaching the crown of a hill.

Messages Page 2 of 2

To POST a message, please Sign In.

Advertisement

Browse by Category

Browse by Vehicle
   View All Vehicles

Browse by Board
Browse by Topic
View All Topics

Edmunds Community

Advertisement