You are here: Forums Pickups Ford Ranger Ford Ranger Transmission Questions

Ford Ranger Transmission Questions

215 messages,  Last post on Nov 08, 2009 at 11:25 AM

You are in the Ford Ranger Forum. Your Host is kcram

What is this discussion about? Ford Ranger, Truck

Messages Page 6 of 23 1 ... 3 4 5 6 7 8 9 ... 23 Prev Next Last

Go To Msg # Search This Discussion

#42 of 215 Why is my O/D flashing on 2001 3.0 auto ranger by thatoneguy Dec 19, 2006 (7:38 pm)
I have a 2001 3.0 ranger and for some reason my o/d light starts flashing once i start driving. When it does come on the truck runs like crap....shifts hard especiall 1st and second.......my dad has the same problem.....hes got a 98 ford ranger and his light is flashing......what can be some things to check....please help Replies to this message: fordtech (Jan 17, 2007 7:13 pm) critterz (Jan 20, 2007 12:50 am) leeschmdt (Sep 27, 2008 8:48 am)
#43 of 215 Re: Why is my O/D flashing on 2001 3.0 auto ranger [thatoneguy] by fordtech Jan 17, 2007 (7:13 pm)
Replying to: thatoneguy (Dec 19, 2006 7:38 pm) Do you have tilt steering? The flashing light is a problem in the trans control system, usually caused by a wire chafe in the column causing the OD OFF button to short out on the column.
#44 of 215 Re: Why is my O/D flashing on 2001 3.0 auto ranger [thatoneguy] by critterz Jan 20, 2007 (12:50 am)
Replying to: thatoneguy (Dec 19, 2006 7:38 pm) I have a 98 ranger that does the same thing once I get up around 50+mph....very hard shift. I took it in for a diag and I was told that i need the following: torque converter tcc solenoid trans wiring harness and filter $ pan gasket....all for a whopping $1023.42....
#45 of 215 99 Ford Ranger Drivetrain Slippage by alamoranger Aug 27, 2007 (12:04 pm)
#46 of 215 99 Ford Ranger Drivetrain Slippage by alamoranger Aug 18, 2007 (7:39 am)
I recently purchased a `99 Ranger 4x4 xlt. I like it a lot. It has the 3.0 L motor, manual 5 speed trans.   It seems to be slipping, but not at the clutch. Are there known problems with either the trans or the rear end? It's only slipping a little bit like at the axle spline or maybe the tail shaft of the trans, not sure.   Thanks for you input.   AlamoRanger Replies to this message: efreck (Aug 27, 2007 12:04 pm)
#47 of 215 Re: 99 Ford Ranger Drivetrain Slippage [alamoranger] by efreck Aug 27, 2007 (12:04 pm)
Replying to: alamoranger (Aug 18, 2007 7:39 am) i have the same truck, several years ago there was a factory recall on the driveshaft,when i got the recall letter mine was doing the exact same thing, im pretty sure you can get that fixed for nothing....cg's!
#48 of 215 2000 Ranger transmission problems by jgkc9ayc Oct 10, 2007 (8:45 am)
I have a 2000 Ford Ranger XLT w/automatic transmission (3spd + OD). Yesterday all of a sudden it didn't want to go into D/OD, so I put it in 2, then D/OD & it did fine. There seems to be a long delay when shifting from P to D/OD or N to D/OD, but not from 2 to D/OD. It also doesn't matter if I have the OD turned on or off. I'm hoping that it's a simple fix...that since I actually have a D/OD that it'll be nothing internal, but i'm no mechanic. Thanks for reading. Replies to this message: jcapshaw (Oct 25, 2007 1:39 pm) psyphon20 (Oct 28, 2007 8:42 pm)
#49 of 215 Slamming into 1st and 2nd by jclark07 Oct 23, 2007 (5:50 pm)
I have a 99 ranger xlt 4.0L auto. when i put it into drive it slams into the first couple gears. any ideas? Replies to this message: bolivar (Oct 24, 2007 12:38 pm)
#50 of 215 do it myself by marty20 Oct 24, 2007 (8:30 am)
I want to change the transmission oil in my '97 Ranger. Do I have to drop the pan in order to do so? If yes, is there a gasket to replace? Is there a filter in the transmission? Replies to this message: bolivar (Oct 24, 2007 12:46 pm) marty20 (Nov 19, 2007 8:40 am) lance420 (Apr 29, 2009 12:22 pm)
#51 of 215 Re: Slamming into 1st and 2nd [jclark07] by bolivar Oct 24, 2007 (12:38 pm)
Replying to: jclark07 (Oct 23, 2007 5:50 pm) I'm not a tranny expert, but one simple thing that will cause slam shifts is a bad vacumn modular valve on the tranny. Or, a big leak in the hose that goes to it.   This will be a small 'can' that plugs into the side of the tranny. It will have a hose, probably a combination of rubber and steel line' that runs from it to a vacumn source on the intake.

Messages Page 6 of 23 1 ... 3 4 5 6 7 8 9 ... 23 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums Pickups Ford Ranger Ford Ranger Transmission Questions