You are here: Forums Pickups Ford Ranger Ford Ranger Transmission Questions

Ford Ranger Transmission Questions

215 messages,  Last post on Nov 08, 2009 at 11:25 AM

You are in the Ford Ranger Forum. Your Host is kcram

What is this discussion about? Ford Ranger, Truck

Messages Page 5 of 23 1 2 3 4 5 6 7 8 ... 23 Prev Next Last

Go To Msg # Search This Discussion

#33 of 215 speed sensor on 2000 transmission by lucyford Jun 20, 2007 (9:54 am)
i was stuck in traffic for a long time, rolling along in 1st gear. traffic thinned out. i tried to go faster, but when i stepped on the gas, i couldnt get out of first gear. brought it to the shop, who couldnt get it out of first either. they just called and said it was going to cost me about $700 to fix becasue i need a speed sensor in the rear end, it has a bad seal, and break fluid is leaking from the left rear wheel. does this warrant $700 worth of work? Replies to this message: 2young (Jul 07, 2008 9:56 pm)
#34 of 215 Manual Trans noise by rhinodecals77 Jul 11, 2007 (7:32 pm)
My Ranger is making noise. When I push the clutch in it makes a rattleing noise and when I am driving. b ut only in the afternoo. I go to work at 5:30 AM and this morning is did not make any noise. Yesterday afternoon it started making noise and this afternoon. Any body got any Ideas.
#35 of 215 1992 ford ranger by stenyrocks Jul 28, 2007 (9:10 am)
I have a 1992 ford ranger auto and need to replace the shifter. I need to know what trany is in this year truck to order a shifter. The pan has 18 bolts.
#36 of 215 2001 Ford Ranger Manual Transmission by randyschultz Jul 28, 2007 (10:03 am)
The third gear grinds when transmission is warmed up. How can I fix this problem?
#37 of 215 95 Ford Ranger 4cyl. by birdyx99 Aug 05, 2007 (11:35 am)
I have a 95 Ford Ranger 5spd. Every now and then, when the truck gets real hot under the hood, the clutch begins to 'slip' and then gets stiff and will not release the clutch. I have to wait 20 or 30 minutes for the engine to 'cool down' and then it runs fine. I have been unable to figure out what causes this. It only happens about twice a year or so. Anyone know what this is or have the simalar problem? Replies to this message: bolivar (Aug 06, 2007 12:01 am)
#38 of 215 Re: 95 Ford Ranger 4cyl. [birdyx99] by bolivar Aug 06, 2007 (12:01 am)
Replying to: birdyx99 (Aug 05, 2007 11:35 am) I don't know much about clutches, but the RAnger has a hydrolic clutch.   I think yours is sticking for some reason. I don't know if flushing the fluid and refilling with new might help...   Or, it might have to have a new slave cylinder put on it.
#39 of 215 03 ranger 2.3l problem/question by rangerjs Aug 09, 2007 (6:51 pm)
First i have a 5 speed manual trans. I wondering what the last sensor is before the driveshaft, I need to know what the name/job of it is so that i can solve my problem. thanks a lot.
#40 of 215 94 Ranger 5speed help by superanger94 Aug 11, 2007 (3:42 am)
my 94 5speed 4cyl is hard getting into 1st gear. it shofts fine but when in neutral I have to go through the gears to get into 1st I dont want to break my shifter any help would be appreciated
#41 of 215 Why is my O/D flashing on 2001 3.0 auto ranger by thatoneguy Jan 20, 2007 (12:50 am)
#42 of 215 Why is my O/D flashing on 2001 3.0 auto ranger by thatoneguy Dec 19, 2006 (7:38 pm)
I have a 2001 3.0 ranger and for some reason my o/d light starts flashing once i start driving. When it does come on the truck runs like crap....shifts hard especiall 1st and second.......my dad has the same problem.....hes got a 98 ford ranger and his light is flashing......what can be some things to check....please help Replies to this message: fordtech (Jan 17, 2007 7:13 pm) critterz (Jan 20, 2007 12:50 am) leeschmdt (Sep 27, 2008 8:48 am)

Messages Page 5 of 23 1 2 3 4 5 6 7 8 ... 23 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums Pickups Ford Ranger Ford Ranger Transmission Questions