You are here: Forums Pickups Ford Ranger Ford Ranger Transmission Questions

Ford Ranger Transmission Questions

215 messages,  Last post on Nov 08, 2009 at 11:25 AM

You are in the Ford Ranger Forum. Your Host is kcram

What is this discussion about? Ford Ranger, Truck

Messages Page 19 of 23 1 ... 16 17 18 19 20 21 22 23 Prev Next Last

Go To Msg # Search This Discussion

#173 of 215 Re: Swapping out the 5speed trans on my 08 Ranger 4x4 [doublej2] by bolivar Feb 24, 2009 (9:45 pm)
Replying to: doublej2 (Feb 24, 2009 9:25 am) It's a truck.   It's a 4x4.   It's going to get bad milage. Replies to this message: doublej2 (Feb 25, 2009 4:13 am)
#174 of 215 Re: Swapping out the 5speed trans on my 08 Ranger 4x4 [bolivar] by doublej2 Feb 25, 2009 (4:13 am)
Replying to: bolivar (Feb 24, 2009 9:45 pm) Hey, thanks for the update! No, really!
#175 of 215 92 ford ranger 4th and 5th gear by jmehoff Mar 19, 2009 (10:15 pm)
I just purchased a '92 for ranger, truck was great on test drive! and ran fine the first couple of hours after purchase. Now when i shift up into 4th gear or 5th/OD, it acts like there is no power coming from the engine. It doesn't seem to be slipping or grinding... Just no power, and if you put the peddle to the floor the whole truck shakes and acts like it wants to die. I know the truck was sitting for a few years prior to my purchase... Could this be related to the fuel pump or filter in any way? And to be honest the first 3 gears are fine, nice and smooth. Any information would be nice, i'd like to fix this problem myself. Replies to this message: cwhary914 (Apr 19, 2009 3:25 pm)
#176 of 215 trans prob. by redneck8 Apr 17, 2009 (2:49 pm)
my question is will a 1988 tras. work on a 1994 both 5-speeds the only diff. is the last letter on the tag everything is the same
#177 of 215 Re: 92 ford ranger 4th and 5th gear [jmehoff] by cwhary914 Apr 19, 2009 (3:25 pm)
Replying to: jmehoff (Mar 19, 2009 10:15 pm) from cwhary914; I have the same year ranger & went through the same problem. The first thing is check spark plugs make sure they are good & gaped right. Next check wires with timing light this will tell you if the wire is mis firing under load. Next check the cap for cracks {HAIR LINE].Next make sure the belt didn"t jump. Take out #1 spark plug and turn the motor by hand to top dead center,make sure cap is on the #1 firing, stick a screw driver down #1 cylinder and move the motor at the same time {If the screw driver comes up the belt jumped ahead -If the screw diver goes down the belt fell behind. If it doesn"t move at all the minute you move the motor it is on top dead center.next make sure the firing order is right.there are two types most are of a U seiries. the firing order is on the top of the engin near the intake. the U is the first letter of your seirial #. In my case I had done all tese thing and still had the problem I fixed my problem by going with a hotter plug,Do to the gas know has ethonal in it.PS. dump 2 cans of muti port fuel cleaner in your tank the gas lines can become corroded from sitting for some time. It takes A day or two of driving to clean them. On the 5 day take your plugs out & claen them agian. It sounds like A lot but It is not your tranny .
#178 of 215 Re: do it myself [marty20] by lance420 Apr 29, 2009 (12:22 pm)
Replying to: marty20 (Oct 24, 2007 8:30 am) u nead a trans filter the fluid well com out around the pan so b rady ps ther is riten on top of dipstik wat fluid to get
#179 of 215 What went wrong. by murderers_r0w Apr 30, 2009 (8:32 am)
Hello, I have an 02 ranger fx4 4ltr auto. the o/d light started flashing and would shift hard into second gear. I had planned on looking into the problem over the weekend, but on the way home yesterday I was going up a hill hen the trans shfted, then there was no power to the wheels. I coasted into a gas station and now I have no reverse either. Can anynoe tell me what happened and what i should do to get the truck back on the road. Replies to this message: lance420 (Apr 30, 2009 4:00 pm) murderers_r0w (Apr 30, 2009 6:12 pm)
#180 of 215 Re: What went wrong. [murderers_r0w] by lance420 Apr 30, 2009 (4:00 pm)
Replying to: murderers_r0w (Apr 30, 2009 8:32 am) i hav a 02 and it ded the same thing o/d flash no revers no drive if it puls in low ger 1 2 its a trans filter if it wont pull at all not even slitey its bands or silanody Replies to this message: murderers_r0w (Apr 30, 2009 6:12 pm)
#181 of 215 Re: What went wrong. [lance420] by murderers_r0w Apr 30, 2009 (6:12 pm)
Replying to: lance420 (Apr 30, 2009 4:00 pm) it makes a whinning sound when I put it in any gear and hit the gas, so i imagine its a worst case scenario. would it be better to rebuild or buy a salvage tranny. which do you think would be cheaper?
#182 of 215 '06 Ranger 4x4 Drive Train Slap by jshap1 May 06, 2009 (8:36 am)
I purchased a used Ranger from a dealer with 30k miles. I notice if I start out slow that there seems to be a slight slap or klunk sound from the rear. I really notice it if I back up then change gears to move forward. The dealer says this is normal and that drive train has some slippage to increase it's life. Anyone heard of this? Replies to this message: bolivar (May 06, 2009 4:21 pm) jshap1 (May 06, 2009 9:38 pm) bolivar (May 07, 2009 12:23 am) and 2 more...

Messages Page 19 of 23 1 ... 16 17 18 19 20 21 22 23 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums Pickups Ford Ranger Ford Ranger Transmission Questions