Ask the Car People.SM


Ford Ranger Transmission Questions

292 messages,  Last post on Jan 09, 2013 at 11:03 PM

You are in the Ford Ranger Forum.

What is this discussion about? Ford Ranger, Truck

Messages Page 14 of 30

#123 of 292 Re: 1999 Ford Ranger - won't go into gear [cfowleron] by nak_machinist

Sep 24, 2008 (12:24 am)

Replying to: cfowleron (Aug 09, 2008 5:35 am)
sounds like there is a pretty good chance slave cylinder is going on ya. i have an 2003 ranger 4x4 with the 4.0. mine acted a fool for about three months and finally left me stranded at work at 2 am none the less. i did the hole bleeding thing and it helped for awhile but ultimately in the end was a waste of time. slave cylinder is internal so you might as well change clutch. just changed mine about two months ago slave and clutch assembly ran bout 300.00 dollars and bout two days work. good luck. oh and when you bleed it pull up on a hill. will help getting air out of system tremendously

#124 of 292 Re: Why is my O/D flashing on 2001 3.0 auto ranger [thatoneguy] by leeschmdt

Sep 27, 2008 (9:48 am)

Replying to: thatoneguy (Dec 19, 2006 8:38 pm)
just wondering if any one had an idea about this issue. i am having the same problem with the O/D not turning off. what was the fix to this problem. my vehicle is a 2000 3.0L automatic ford ranger

#125 of 292 Re: 1999 Ford Ranger - won't go into gear [nak_machinist] by cfowleron

Sep 30, 2008 (9:37 pm)

Replying to: nak_machinist (Sep 24, 2008 12:24 am)
That's what I was afraid of. LOL Thanks for the advice I appreciate it. I was hoping against that.

#126 of 292 2005 ranger..clunk noise by mgunde

Oct 09, 2008 (5:25 pm)

When I start my truck in the morning or after work, there is a clunking thud sound that comes from the tranny area, it only happens when the truck is cold, its there only for the initial start up and goes away, its like something is being released any ideas on what this is?

#127 of 292 2005 ranger..cold air by mgunde

Oct 09, 2008 (5:27 pm)

Even with the fan off, there's always cold air coming out of the vents, whats up with this?

#128 of 292 2000 ranger wont shift by maria16

Oct 16, 2008 (4:45 pm)

Help! My 2000 ranger currently will not shift gears and the check engine and abs lights are on, and the o/d light flashes. Also, the speedometer doesnt work. Does anyone know why this is happening and what needs to be done to fix it? Ty!

#129 of 292 Re: 2000 ranger wont shift [maria16] by bolivar

Oct 17, 2008 (2:04 am)

Replying to: maria16 (Oct 16, 2008 4:45 pm)
I think this is a 'standard' problem for Rangers, but I'm not sure of the problem. It may be the ABS sensor that is in the rear differential has failed, and it causes all these problems. If this is it, it's not a terrible expensive repair. Remove the electrical connection, one bolt, pull out the old sensor, put a new one it.

#130 of 292 Re: 2000 ranger wont shift [maria16] by marco32110

Oct 22, 2008 (3:37 pm)

Replying to: maria16 (Oct 16, 2008 4:45 pm)
hello, i was wondering if you were able to figure out the problem with your truck? My ranger actually did the same thing to me today on the way to work! If you have already fixed it could you tell me what the problem was and to fix it? thanks!!

#131 of 292 Re: 2000 ranger wont shift [marco32110] by maria16

Oct 23, 2008 (11:13 am)

Replying to: marco32110 (Oct 22, 2008 3:37 pm)
yes I did get it fixed, it was the abs speed sensor and the part is only about $30. However with labor, I paid a little over $100. Hope this helps!

#132 of 292 Re: 2000 ranger wont shift [maria16] by bolivar

Oct 23, 2008 (9:04 pm)

Replying to: maria16 (Oct 23, 2008 11:13 am)
Ah, so I got one right....

Messages Page 14 of 30

To POST a message, please Sign In.

Advertisement

Browse by Category

Browse by Vehicle
   View All Vehicles

Browse by Board
Browse by Topic
View All Topics

Edmunds Community

Advertisement