Sign In Join 



Chevy Blazer GMC Jimmy Electrical Problems

460 messages,  Last post on Oct 30, 2009 at 4:35 PM

You are in the Chevrolet Blazer Forum. Your Hosts are steve_ & tidester

What is this discussion about? Chevrolet, GMC Jimmy, SUV


Messages Page 34 of 47
1
...
31
32
33
34
35
36
37
...
47
Prev
Next
Last
Go To Msg #
Search This Discussion

#329 of 460
Re: Figured out the problem! Somewhat?!?! [coachhill] by tigers02
Sep 10, 2008 (1:17 pm)
Reply

Replying to: coachhill (Sep 16, 2007 8:48 am)

My problem sounds exactly like yours...left the tailgate open the other night in the rain and now the pushbutton, power locks, and rear hatch actuator operate intermittently. I dissassembled everything but couldn't figure out how to remove the pushbutton/lock assembly for cleaning. This post was a year old but do you remember how to remove the lock.
#330 of 460
Re: replacing multifunction switch [Mr_Shiftright] by bear19
Sep 13, 2008 (1:43 pm)
Reply

Replying to: Mr_Shiftright (Aug 25, 2008 5:42 pm)

We found out that our problem was the flasher for the 4-ways and the flasher for the turn signals. Luckily the parts store would take back the multi-purpose switch that I bought.I found out that the multi-purpose switch can be removed and replaced without pulling the steering column. A #25 torx bit might have to be modified to get one screw out, but if you take your time, it can be done. A #5 internal torx soccet is also needed. Thank you for your help, and I hope this will help someone. (The switch alone cost about $200.00!)
#331 of 460
Re: 97 blazer electrical problem [jeffery57] by mvicars
Sep 17, 2008 (5:27 pm)
Reply

Replying to: jeffery57 (Nov 27, 2007 8:59 am)

I'm also having the same problem on my 97 GMC Jimmy. I suspect the grounds but I haven't verified it. Have you fixed the problem yet? What was the fix?
#332 of 460
97 GMC Jimmy has a bad miss by tommyj2
Oct 08, 2008 (7:16 pm)
Reply
97 GMC Jimmy with a V6 Vortec, motor was bought from Advance and has around 40000 miles. I didn't put the motor in, it was already installed when I bought it. Hope someone can help me with this miss problem, I will try to explain it the best that I can. First off, new plugs, new plug wires, new coil pack, fuel filter and air filter. Catalytic converter has been removed. No Check engine light is on. The vehicle starts perfect and idles perfect, but when you go up a hill it sometimes has a bad hesitation like you are letting off the fuel back and forth, give it more gas and it quits. Then sometimes on flat ground at 55 mph it does the same thing. Sometimes I can pull into a parking lot at 3 mph or at an idle and the motor has a violent stutter to it. That has only happened twice. So can anyone enlighten me on this subject??
#333 of 460
Re: 97 GMC Jimmy has a bad miss [tommyj2] by mwolf9000
Oct 09, 2008 (5:18 am)
Reply

Replying to: tommyj2 (Oct 08, 2008 7:16 pm)

Have you checked the fuel pressure from the fuel pump?
#334 of 460
Re: 97 GMC Jimmy has a bad miss [tommyj2] by judastouch
Oct 09, 2008 (6:14 am)
Reply

Replying to: tommyj2 (Oct 08, 2008 7:16 pm)

How's the inside of the distributor cap look? GMC issued a recall/repair on the distributors--the bottoms of the units themselves have little apertures covered with metal screens. (If memory serves, the apertures were to provide ventilation and the screens to keep road debris from getting into the distributor.) The screens trap moisture, which causes the inside of the cap to corrode, and causes misfiring similar to what you're describing.
 
If the inside of the cap is corroded, pull the distributor and yank out those screens.
 
Previous poster's question about fuel pressure is also a good one--check your fuel pressure.
#335 of 460
Re: 97 GMC Jimmy has a bad miss [mwolf9000] by ealvarez
Oct 18, 2008 (11:40 am)
Reply

Replying to: mwolf9000 (Oct 09, 2008 5:18 am)

I had a similar problem with my 98 GMC Jimmy and after a while stop running all together it turned out to be the fuel pump inside the tank. Pump is about $280, Good luck
#336 of 460
Transmission Problem? by ealvarez
Oct 18, 2008 (11:43 am)
Reply
My Jimmy was running fine one day next day It was hesitating and not shifting on time and when shift into reverse the truck would not move. Can someone tell me If Im going to need a new transmission or maybe a filter and fluid change will take care of this problem?
#337 of 460
Re: replacing multifunction switch [bear19] by badassken2004
Oct 25, 2008 (6:29 pm)
Reply

Replying to: bear19 (Aug 25, 2008 5:16 pm)

I'm having the same problem with my 97, Did you figure it out?
#338 of 460
97 Blazer no hazzards or brake lights by badassken2004
Oct 25, 2008 (7:00 pm)
Reply
Took out brake light switch went back to get tools. I opened back hatch and my center light came on puzzled. Can any 1 help

Messages Page 34 of 47
1
...
31
32
33
34
35
36
37
...
47
Prev
Next
Last
Go To Msg #
Search This Discussion
To POST a message, please Sign In.

New? Join Now!

Forum Tools

Please sign in.
Email Address:

Password:

Forgot Password?

Search Forums

Enter Keyword(s)

Advanced Search

Browse by Vehicle



View All Vehicles
Advertisement
Ask the Community
See What People Are Asking

Browse by Board

Browse by Topic


View All Topics

Today's Chats

Advertisement