- #3 of 472
-
Re: 2001 Chevy Blazer: Electrical Problems [tigerperm]
by repairdog
-
Jun 26, 2006 (2:41 am)
-
|
|
Replying to: tigerperm (Jun 25, 2006 5:49 pm)
You are lucky this time cause the flasher is a recall item (had mine done free) that is part of the mulifunction switch - all they do is pop the harzard switch out the top of the column and put a new one in - due to failed brake lights because the flashers use same circuit but the top mount or third brake light still works. This should cure the problem. Behind the glove box are 2 relays or canisters 1 for flashers and 1 for blinkers - thats where you hear the noise I'd guess. Earlier models often replace the whole multif switch to solve the noise but this is the part that should do it - for free so let all know how it works out.
|
- #4 of 472
-
Re: 2001 Chevy Blazer: Electrical Problems [repairdog]
by cbarnett
-
Jul 14, 2006 (5:36 am)
-
|
|
Replying to: repairdog (Jun 26, 2006 2:41 am)
My blazer's brake lights have failed but the top mount still works. Called my local dealership and they said was no recall on this. Can you give me some more specifics on the recall that you are speaking of.
|
- #5 of 472
-
Re: 2001 Chevy Blazer: Electrical Problems [cbarnett]
by repairdog
-
Jul 14, 2006 (8:14 am)
-
|
|
Replying to: cbarnett (Jul 14, 2006 5:36 am)
Its the flasher switch on top of the steering column and mine was replaced on a recall - run the VIN # and it will come up on their computer - if not ask for the service manager. Lazy guys sounds like.
|
- #6 of 472
-
96 Chevy Blazer: Power Door lock failure
by hybridpr
-
Jul 18, 2006 (10:56 am)
-
|
a few months ago the power door locks just stopped working. also the keyless entry no longer works when i disarm the car alarm. when i press the lock or unlock button on the door, i hear a clicking coming from inside the glovebox from the relays. could that be where my problem is? whats the fix for this?
thanks,
joel
|
- #7 of 472
-
Re: 96 Chevy Blazer: Power Door lock failure [hybridpr]
by repairdog
-
Jul 19, 2006 (3:02 am)
-
|
|
Replying to: hybridpr (Jul 18, 2006 10:56 am)
see answer in other section - don't double post!
|
- #8 of 472
-
stalling problems
by bigjoe85
-
Jul 30, 2006 (2:04 pm)
-
|
|
I have an 01 blazer 4.3 vortec and Im having trouble I think with the feul system. When I would pull up to a stop light sat there longer than 5 min. it will cut off on me and it and now its shutting off while im driving down the road. I have no problem starting it backup though. Fuel pump or possibly injectors?
|
- #9 of 472
-
Re: stalling problems [bigjoe85]
by repairdog
-
Jul 31, 2006 (5:43 am)
-
|
|
Replying to: bigjoe85 (Jul 30, 2006 2:04 pm)
Don't double post - see answer in starting stalling post.
|
- #10 of 472
-
Re: 2001 Chevy Blazer: Electrical Problems [tigerperm]
by jimmy_biehn
-
Aug 17, 2006 (8:05 am)
-
|
|
Replying to: tigerperm (Jun 25, 2006 5:49 pm)
Had the exact same problem on 98 Blazer. Issue was the turn signal switch mechanism. Unfortunately part was $250 & $250 labor to install since steering column has to be disassembled to install it. Only 80k on vehicle at the time. Low grade parts appears to be the real issue ....
|
- #11 of 472
-
rough runner in damp weather
by boots76
-
Aug 31, 2006 (4:01 pm)
-
|
|
98 s-10 100k miles did cap ,rotor, plugs ,wires,. after a good rain runs rough under load no power. mechanic thinks fuel pump ,say's computer read out low pressure. i think electrical. only in damp conditions does this happen after dries out ok. help
|
- #12 of 472
-
Re: rough runner in damp weather [boots76]
by repairdog
-
Aug 31, 2006 (5:07 pm)
-
|
|
Replying to: boots76 (Aug 31, 2006 4:01 pm)
Fuel pressure test should show 60psi at key on engine off and it should hold it (pump only comes for for 2 seconds) then about 54psi running. If only when damp could be a wet connector at the crank sensor under the front of the engine. Have you put a new fuel filter on (every 25k miles) under frame by drivers seat. The pumps do often fail around then and use Delco replacement about $300 part online at rockauto or gmpartsdirect but have to drop tank. Also how is the battery and alternator - is the gage reading about 14V running - don't like low voltage so if its failing and reading below 12 have them tested free at most stores in car.
|