- #26 of 82
-
Re: '94' mitsubishi diamante car stereo code [rockinout88]
by jefany4
-
Jan 04, 2007 (10:40 am)
-
|
|
Replying to: rockinout88 (Jan 04, 2007 8:09 am)
you dont need remove the dash to get the stereo out........remove cent coin tray by shifter then 2 screws in the hole,then side of center console screws..then move shifter back as fas as can then stereo should be removable......find parts number and call mits. dealer get parts dept. and tell parts dept. the stereo part number and they will give you the code!
|
- #27 of 82
-
Re: '94' mitsubishi diamante car stereo code [jefany4]
by jefany4
-
Jan 04, 2007 (10:42 am)
-
|
|
Replying to: jefany4 (Jan 04, 2007 10:40 am)
or go to this site for removal instructions.....hope it helps!
http://www.carstereohelp.com/
|
- #28 of 82
-
Re: 93' Mitsubishi diamante start then wont start [misty25]
by jefany4
-
Jan 04, 2007 (11:01 am)
-
|
|
Replying to: misty25 (Dec 20, 2006 9:06 am)
hi misty,
it could be as easy as the battery cables!
check that all connections are clean at all the connections to the battery and the block!
check both ends of the black cable(negative)
check both ends of the red cable(positive)
most times if the negative cable is loose you will experience this........i have and cleaned all connections and went from there.........good luck!
|
- #29 of 82
-
Re: 93' Mitsubishi diamante start then wont start [jefany4]
by misty25
-
Jan 05, 2007 (8:11 am)
-
|
|
Replying to: jefany4 (Jan 04, 2007 11:01 am)
I had the battery check its fine. but the other night while i was driving it the engine shut off i waited a few min got it to restart drove it a short distance then shut of then restarted drove for a while puttered then shut off then restarted and i was able to get it home haven't driven it since then cause don't know whats going on. anyone have any suggestions?
|
- #30 of 82
-
Re: 93' Mitsubishi diamante start then wont start [misty25]
by ss4ela
-
Feb 09, 2007 (7:26 pm)
-
|
|
Replying to: misty25 (Jan 05, 2007 8:11 am)
I had a similar prob w/my 92 LS, except mine would run 4 about the first 45 min (when cold) in the am, then stall,would not start until it sat and cooled 4 about 15 min. then would run 4 another 5-10 min.Mine turned out 2 be the ECU.(Engine Control Unit). Found 1 online for 425.00(joined Planet Salvage). But yours sounds like a possible fuel pump problem. As an auto tech, I have seen this symptom more than a few times leading to the electic fuel pump. Pump is universal, so it is fairly inexpensive,but is located in fuel tank,high labor. easy 2 diag.-just have mech. friend install fuel pressure guage, make sure its up 2 spec.,& make sure it holds steady pressure w/key on. if not,replace. Hope this helps,E
|
- #31 of 82
-
Re: Mitsubishi Diamante 2003 Heater Core [tlye]
by jerryterry22
-
Feb 21, 2007 (8:35 pm)
-
|
|
Replying to: tlye (Jul 11, 2006 2:04 pm)
I had antifreeze leakage on the driver's side carpet, odor and residue on inside of the windows -fog. (2002, 6 cyl., 3.5 liter).
The Mitsubishi Service "greeter" told me the the heater core was on the passenger side and that the dampness under the driver's feet might be from a hole - going through water!
I had a mechanic who fixed only heater cores replace it.
He told me he had to remove the entire dash and huge number of fasteners.
|
- #32 of 82
-
Re: Mitsubishi Diamante 2003 Heater Core [jerryterry22]
by diamoney
-
Feb 22, 2007 (8:20 am)
-
|
|
Replying to: jerryterry22 (Feb 21, 2007 8:35 pm)
I had the same thing happen right when I picked up m rig.. (2002) they made me pay for parts, but the labor was picked up.. any yeah, it does not sound like a fun one..
|
- #33 of 82
-
Satelite Radio
by diamoney
-
Feb 22, 2007 (12:48 pm)
-
|
I have a 02 Diamante, anyone ever install an XM/Sirius radio in their rig? If not, know anyone who may have taken on this task?
My question is this, what hardward did you need and where did you install it?
|
- #34 of 82
-
Krazy 1997 Mitsubishi Transmission
by ldelaney
-
Feb 23, 2007 (11:14 pm)
-
|
Just before I stop, the transmission does a hard downshift and sometimes lurches forward. Major transmission company overhauled but still does same thing only not as bad. They reflash the tranny, works fine until shut off, then does same thing when restarted. What gives?  
|
- #35 of 82
-
Re: Dipping and swerving [diamoney]
by manybrews
-
Mar 20, 2007 (5:07 pm)
-
|
|
Replying to: diamoney (Sep 05, 2006 12:57 pm)
that is due to worn lower "pillow" bushings in the rear knuckle.
they can be replaced seperatly.
|
![[F]](http://a332.g.akamai.net/f/332/936/12h/www.edmunds.com/media/townhall/webxicons/site.gif){kind=small}
Forums
Sedans 
