Sign In Join 



Chevy Blazer Starting and Stalling Problems

326 messages,  Last post on Nov 27, 2009 at 10:50 AM

You are in the Chevrolet Blazer Forum. Your Hosts are steve_ & tidester

What is this discussion about? Chevrolet Blazer, GMC Jimmy, SUV


Messages Page 32 of 33
1
...
27
28
29
30
31
32
33
Prev
Next
Last
Go To Msg #
Search This Discussion

#309 of 326
Re: 1985 S10 BLAZER [jlflemmons] by jeffh20man
Oct 06, 2009 (9:35 am)
Reply

Replying to: jlflemmons (Oct 06, 2009 9:11 am)

I will check that once the switch gets here. Thanks and I will let you know !
#310 of 326
1992 chevy 4.3 v6 won,t idle by zedd3111
Oct 24, 2009 (3:09 pm)
Reply
I have a 1992 chevy pickup with a 4.3 v6. When i crank it i have to throttle the gas to keep it running. If i unplug the map sensor it will run at a high idle. I have tested the map sensor and it tests fine, i have even replaced it but that didn't work. I have replaced the ECM, IAC,TPS,EGR valve, fuel filter. I have cleaned the throttle body. I have checked the vacuum lines, distributor, wires and plugs. The vacuum selinoid works fine and the spark control module works fine.I had a diagnostic tool run on it but no codes. I have ohmed out the wiring and found no breaks. Can anyone give me some ideas on what this problem can be? Please help!!!
#311 of 326
95 Blazer stalling by jerzyboarder
Oct 25, 2009 (3:40 pm)
Reply
I have a 95 chevy blazer automatic with a 4.3 vortex. When I drive it the RPMs jump around and then it stalls out if I hit the brakes. Does anyone have any Ideas of what may be wrong?
#312 of 326
Re: 1992 chevy 4.3 v6 won,t idle [zedd3111] by marblaze
Oct 28, 2009 (5:23 pm)
Reply

Replying to: zedd3111 (Oct 24, 2009 3:09 pm)

I HAD A SIMILAR PROBLEM AS TO WHERE MY 4.3 WOULD IDLE HIGH THEN DROP TO ALMOST STALLING IT WAS MY THROTTLE POSITION SENSOR JUST A CHANCE .
#313 of 326
Re: blazer won't start [blondie16] by marblaze
Oct 28, 2009 (5:31 pm)
Reply

Replying to: blondie16 (Aug 10, 2008 6:00 am)

I JUST CHANGED MY FUEL PRESSURE REGULATOR TODAY IT IS MOUNTED ON THE BACK OF THE SPIDER JET , THE SPIDER JET IS UNDER THE PLENUM INTAKE WHICH IS MOUNTED ON TOP OF THE THE ALUMINUM INTAKE ITS A FAIRLY EASY JOB JUST REMEMBER THE PLENUM INTAKE IS PLASTIC WHEN YOU START TO TIGHTEN YOUR BOLTS BACK DOWN IF YOU NEED ANY HELP FEEL FREE TO ASK ME I JUST DID THIS JOB TODAY IT IS TIME CONSUMING DUE TO ALOT OF THINGS TO REMOVE ,JUST TAKE YOUR TIME , BE SURE TO GET YOUR PLENUM GASKET SET BEFORE HAND AND WHILE WORKING ON REPLACING FUEL PRESSURE REGULATOR COVER YOUR INTAKE PORTS WITH RAGS SO NOT TO DROP ANY -PARTS INTO THE CHAMBERS
#314 of 326
Re: 1992 chevy 4.3 v6 won,t idle [marblaze] by tidester HOST
Oct 28, 2009 (9:19 pm)
Reply

Replying to: marblaze (Oct 28, 2009 5:23 pm)

I recommend against using ALL CAPS when posting a message in our Forums. People tend to skip past messages written in ALL CAPS because they find them hard to read.
 
tidester, host
SUVs and Smart Shopper
#315 of 326
97 Blazer starting problem by nbaker2005
Nov 03, 2009 (6:13 am)
Reply
Our 97 Blazer has an intermittent starting problem. The car has a new fuel pump (60PSI) and filter, good plugs, wires and spark when the problem occurs. I have pulled the plugs and found them wet and you can smell fuel when the problem occurs. When the car sits for longer than day and especially when its wet, it won't start. It has spark and fuel it seems as if the timing maybe off and not firing at the proper time. There never has been any back fire to indicate bad timing, it doesn't even try to fire. I have cleaned the plugs when they are wet and put them back in and still no start. The last time this happened I tried cranking for long periods and short periods. In doing so I found that if I did not turn the key all the way to off it would hit on the next attempt. Doing this (going from start to run and back to start) the car did finally start, but the engine raced at about 2500 rpm. I shut it off and started it again a few times and it finally came back to a normal idle. Anyone ever have this type of problem and knows where to look?
#316 of 326
Error codes by marblaze
Nov 03, 2009 (8:49 am)
Reply
my 99 blazer has a starting problem when cold , the sevice engine soon light is on i had it checked at the auto parts store scanner read( fuel lean ) anyone know what this means??????????????????
#317 of 326
Re: 97 Blazer starting problem [nbaker2005] by jlflemmons
Nov 03, 2009 (3:49 pm)
Reply

Replying to: nbaker2005 (Nov 03, 2009 6:13 am)

That sure sounds like a CPI spider leak, or fuel regulator leaking. Search the Blazer boards for injector leak, CPI problems, fuel spider and you will probably find your answer.
#318 of 326
Re: Error codes [marblaze] by jlflemmons
Nov 03, 2009 (3:50 pm)
Reply

Replying to: marblaze (Nov 03, 2009 8:49 am)

Do you have the exact code the reader got off the computer?

Messages Page 32 of 33
1
...
27
28
29
30
31
32
33
Prev
Next
Last
Go To Msg #
Search This Discussion
To POST a message, please Sign In.

New? Join Now!

Forum Tools

Please sign in.
Email Address:

Password:

Forgot Password?

Search Forums

Enter Keyword(s)

Advanced Search

Browse by Vehicle



View All Vehicles
Advertisement
Ask the Community
See What People Are Asking

Browse by Board

Browse by Topic


View All Topics
Advertisement