Sign In Join 



Chevy Blazer Starting and Stalling Problems

326 messages,  Last post on Nov 27, 2009 at 10:50 AM

You are in the Chevrolet Blazer Forum. Your Hosts are steve_ & tidester

What is this discussion about? Chevrolet Blazer, GMC Jimmy, SUV


Messages Page 31 of 33
1
...
27
28
29
30
31
32
33
Prev
Next
Last
Go To Msg #
Search This Discussion

#297 of 326
Re: Starting issue [00blazer1] by elaney1981
Sep 22, 2009 (9:18 am)
Reply

Replying to: 00blazer1 (Sep 22, 2009 7:24 am)

I have had that problem with my 98 jimmy and it was the fuel pressure regulator, If I were you I would do the whole assembly. The job is nothing at all. basic tools. Look on this site to find instructions, it is easy trust me.
#298 of 326
starting problems by 00blazer1
Sep 22, 2009 (10:41 am)
Reply
any idea what the parts cost?
#299 of 326
Blazer ECM by chad21
Sep 26, 2009 (5:14 pm)
Reply
My blazer died and won't restart. I've tested fuel,it's ok. I've replaced the coil,dist.cap and rotor button,and the shaft sensor; now all it is doing is blowing the ECM fuse every time I turn the switch on. Please help!
#301 of 326
2002 chevy blazer stalling problem by brendon77
Oct 02, 2009 (4:05 am)
Reply
i have a 2002 chevy blazer 4wd. i start it up it fires and dies. the problem is intermittent. it happens every 2 weeks or so and after several attempts it will be fine and drive.
#302 of 326
Re: 2002 chevy blazer stalling problem [brendon77] by dp2226
Oct 02, 2009 (7:16 am)
Reply

Replying to: brendon77 (Oct 02, 2009 4:05 am)

This could be a real stretch but I had a similar problem where I had trouble getting the truck to start every few days where I had to turn the key a couple times, then would stutter when first going, a couple times just stalled out. Drove myself nuts with hoses, fuel pressure etc.
 
Had a rusted battery terminal screw. It was being shaken when driving, caused the battery not to charge properly when driving. An easy test is to jiggle each wire separately(obviously do not create a connection with yourself and the car). You will hear the power go on and off.
 
Again probably not it but was listed as one of the first things to check and I ignored it because had one of those duralast batteries
#303 of 326
"95 Blazer no spark by chad21
Oct 04, 2009 (1:58 pm)
Reply
Hey guys, my blazer died and wont restart. I smell gas after 2 turn-overs,but cant find any spark from the coil. also every time I turn the switch, my ECM/Batt fuse blows. Any ideas?
#304 of 326
Re: "95 Blazer no spark [chad21] by elaney1981
Oct 05, 2009 (5:21 am)
Reply

Replying to: chad21 (Oct 04, 2009 1:58 pm)

I think it might be the crank position sensor which is located on the front of the engine near the harmonic balancer and main pully. Try this first, its cheap! 20 dolars if that. if that will not work then its the ecm, it being bad will send mixed signals. But i would try the crank position sensor first.
#305 of 326
1985 s 10 blazer by jeffh20man
Oct 05, 2009 (12:42 pm)
Reply
I need to keep this truck running but every time it gets hot, it stalls out. Unless you have your foot on the gas and the idle high, it will stall out every time. Does not
do it when its cold . I have had a new motor put in , rebuilt carb (for high altitude)
new fuel pump and water pump. Truck should run great......does for about 10 minutes and then it stalls. Any suggestions
#306 of 326
Re: 1985 s 10 blazer [jeffh20man] by jlflemmons
Oct 05, 2009 (3:08 pm)
Reply

Replying to: jeffh20man (Oct 05, 2009 12:42 pm)

New coil? You are describing a very typical coil failure, and I doubt the new engine came with one.

Messages Page 31 of 33
1
...
27
28
29
30
31
32
33
Prev
Next
Last
Go To Msg #
Search This Discussion
To POST a message, please Sign In.

New? Join Now!

Forum Tools

Please sign in.
Email Address:

Password:

Forgot Password?

Search Forums

Enter Keyword(s)

Advanced Search

Browse by Vehicle



View All Vehicles
Advertisement
Ask the Community
See What People Are Asking

Browse by Board

Browse by Topic


View All Topics

Today's Chats

Advertisement