You are here:
Forums
Pickups
Ford Ranger
Ford Ranger Starting Problems

188 messages, Last post on Nov 14, 2009 at 2:23 PM
You are in the Ford Ranger Forum. Your Host is kcram
|
Replying to: peloquinac (Jun 13, 2008 4:12 pm) Otherwise, you are going to have to go into the 'usual' search for a power drain. Get a ampmeter that can handle 2 or 3 or more amps. Pull a fuse and put the ampmeter across the fuse contacts until you find the circuit that is pulling a big amp load. This just narrows the problem down to one circuit. Or get a Test Lamp that can also handle a couple of amps thru it. Pull one cable from the battery and wire the test lamp in series from the loose cable to the battery. The lamp should light up. Start pulling fuses until the light goes out, or dims down a lot. Again this just narrows the problem down to a circuit. To do further testing may just be guesswork of unplugging various things in this questionable circuit. Looking for pinched wires, etc. Finding what is draining a battery can be one of the toughest problems in a car. In may cases, a factory shop manual with wiring schemetic will be necessary. A tech that is a 'mechanic' and knows little about electronics may not be able to do this. P.S. If you have a sticking relay, the above testing may not work. Removing the power to a stuck relay, when you pull a fuse or remove battery cable, might cause it to reset correctly and then you will not be able to see the drain on a meter. Good luck. Finding a power drain is tough. I had a Caddy that would kill a battery in 2 days. Dealer did find it - replaced the radio/cassette/CD player. This probably was a thousand dollar part. Happy it was under warranty.
|
|
|
|
|
Replying to: bolivar (Jun 14, 2008 12:22 am) P.S. Any idea where to find a wiring diagram for a 2003 Ford Ranger. I'm thinking of yanking the security system.
|
|
| My 05 ranger shut off yesterday while at idle. It sputtered and shut off. It will not re-start..it turns over but won't start at all. No warning lights have come on prior to that and I have had no other problems til now. What else can I do?? | |
|
Replying to: peloquinac (Jun 14, 2008 5:26 am)
|
|
|
Replying to: muncy (Apr 04, 2008 5:25 pm) |
|
|
|
|
Replying to: bolivar (Jun 14, 2008 3:42 pm) |
|
I have a 2003 Ranger XLT 2wd - new problem: sometimes I can't turn the key in the ignition - it's stuck until you jiggle the steering wheel. I don't want to wait until it gets permanently stuck off and needs to be drilled--- So, is there any alternative to taking it to a Ford Dealer to get the lock cylinder replaced ? I also don''t want to end up with 2 different keys - one for the ignition and one for the doors. This seems to be a Ford problem-same thing happend on my Villager and the dealer wanted $400 to fix it. Any ideas ?
|
|
|
Replying to: ronz1 (Jun 24, 2008 7:09 am) |
|
| i drove my truck to store, tried to start 3min later cranked like it wanted to start but didn't check for spark good checked fuel at in injectors good ?????? | |
| Similar to Arnieboy1, I stopped off at a store and when I turned the key to go home, all I got was a hard click. The engine would not even turn over. I turned the lights on, but even they did not dim after the click. No power to what? | |
You are here:
Forums
Pickups
Ford Ranger
Ford Ranger Starting Problems
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2010 Ford Ranger



Browse by Board
Browse by Topic
Today's Chats