You are here: Forums Pickups Ford Ranger Ford Ranger Starting Problems

Ford Ranger Starting Problems

188 messages,  Last post on Nov 14, 2009 at 2:23 PM

You are in the Ford Ranger Forum. Your Host is kcram

What is this discussion about? Ford Ranger, Truck

Messages Page 7 of 20 1 ... 4 5 6 7 8 9 10 ... 20 Prev Next Last

Go To Msg # Search This Discussion

#54 of 188 Re: 90 ranger starting problems [jason200x] by bolivar Nov 07, 2007 (12:20 pm)
Replying to: jason200x (Nov 07, 2007 12:02 pm) A couple of possibilities: - A weak fuel pump. Any motor is harder to start when cold, and you may not be getting enough pressure to the injectors. The fuel rail will have a schrader connection, where you can attach a fuel pressure guage. Sorry, I don't know the correct pressures you should look for.   - There probably are two temperature sensors on the motor. (Although, with a motor transplant, who knows what is still hooked up....) One sensor drives the temp guage. The other sensor tells the computer that it is a 'cold start' and changes the gas delivery - basically I think this means it delivers more gas by keeping the injectors open for a longer time. If this sensor is bad, the computer does not know it is a cold start and uses the 'regular' gas delivery, which mean it is tough to start when cold. But warmed up, the 'regular' gas delivery is fine and the motor starts fine.   I don't know exactly where these temp sensor are at, but my guess would be on or near the thermostat housing. Another guess would be that the sensor to the computer will have a pair of wires, black and yellow, twisted together. Replacing this sensor might be worth a try.
#55 of 188 Re: 90 ranger starting problems [jason200x] by rangerboy1 Nov 07, 2007 (6:02 pm)
Replying to: jason200x (Nov 07, 2007 12:02 pm) I discovered the solution (with some insight from a professional mechanic) to my starting problem was so simple I completely overlooked it: a bad connection at the negative post on the battery. The clamp on the post had been replaced bythe previous owner and the wiring coming from it was not making a good connection. I clened the wiring, put a closed-ended crimp connection on each wire, and reconnected to post clamp. I have had no problems since.
#56 of 188 Ranger hard start has become ranger won't quite run... by amazonafaun Nov 27, 2007 (9:54 am)
My beloved, super-dependable 1998 Ranger 4.0L has suddenly become very hard to start and will only run with pressure on the accelerator. It has had a couple of hard start moments over the last few months (temperature independent), but nothing consistent enough to be a clear problem. However, yesterday morning (it was below freezing) it would turn over, but not start, unless I gave it quite a bit of gas, and once started, it would only remain running with pressure on the accelerator.   I should also admit that I test drove a chevy the night before, and my truck may simply be punishing me- however any insights as to how to make my truck happy again would be much appreciated. My previous ranger had serious fuel pump issues (went through three), so I am wondering if that could be happening to this truck as well.   Thanks! Replies to this message: hubbles (Nov 27, 2007 10:13 am)
#57 of 188 Re: Ranger hard start has become ranger won't quite run... [amazonafaun] by hubbles Nov 27, 2007 (10:13 am)
Replying to: amazonafaun (Nov 27, 2007 9:54 am) To the previous post with a 1998 Ranger 4.0L, that sounds like an Idle Air Control Valve (IAC). I had that problem and was able to temporally fix it by removing it, blowing high pressure air into it to clean it, and putting it back (then driving to the store to get a new one). If it is the IAC, it will start and run fine if you depress the gas, but if you totally let off the gas it stalls out.   Hope that helped
#58 of 188 Ranger ignition problem. by cskoda Nov 30, 2007 (12:32 pm)
I have a 1996 ranger with six cylinder. When I turn the key I get nothing. No radio no dash no blower motor and engine will not turn over. I do have headlights and emergency flashers. The car has sat for months and the battery died. I changed the ignition switch, battery, solenoid cleaned all battery contacts body ground contacts and starter contact and still nothing. I checked all fuses at the dash location and at the power distribution box under the hood and everything is ok. . Turn the key and it's like it's dead. Anyone that can help I would appreciate it. I'm trying to get it running for a kid in the neighborhood.
#59 of 188 problem starting by revmred Dec 18, 2007 (2:25 pm)
I have a problem starting my ranger, I replaced the battery after a severe cold snap thinking this was the problem, yet it continues, I thought maybe cables you can boost it off and it wills tart. I boosted it off today drove it about 3 miles. Killed it and tried to restart, it was like there was no battery at all. HELP!! I took cables off and am going to replace them, but should I have started somewhere else, or should I try something else first? Replies to this message: obyone (Dec 20, 2007 2:35 am) fotd1 (Dec 26, 2007 11:48 am)
#60 of 188 Re: problem starting [revmred] by obyone Dec 20, 2007 (2:35 am)
Replying to: revmred (Dec 18, 2007 2:25 pm) Did you have your alternator checked out? That may be your problem. Replies to this message: fotd1 (Dec 26, 2007 11:48 am)
#61 of 188 Re: problem starting [obyone] by fotd1 Dec 26, 2007 (11:48 am)
Replying to: obyone (Dec 20, 2007 2:35 am) The original symptoms did not state whether the engine turned over, but did not start. There are a couple of known issues with some years of Ford Rangers that affect starting. The crankshaft position sensor goes bad; the engine turns over, but spark and injector firing are intermittent-if at all. Longer shot could be a problem with the wiring harness (cracked insulation). If the engine doesn't crank (assuming good battery) check interlock switch on clutch/auto trans.   fotd1
#62 of 188 Re: Electrical Problems at Start-up [rangerboy1] by 98rangerv6 Dec 26, 2007 (11:03 pm)
Replying to: rangerboy1 (Oct 01, 2007 1:36 pm) i had replaced the alternator in my ranger then the battery went bad it was brand new i found out by process of elemination it was the fusabile link under the relay box by the brake booster
#63 of 188 2008 Ford Ranger won't start by donnap1 Dec 27, 2007 (8:27 pm)
I am glad that I found your forum. We purchased a 2008 Ford Ranger 3 months ago, everything was good until it got cold outside. As soon as the temperature is around 0% C. the truck turns over but won't start. (usually have to try 3-4 times before it finally starts, then runs well, as soon as the engine gets cold, same thing, won't start)   It has been in the shop more in the last month then at home.   The dealership so far has replaced the fuel pump, fuse panel, a few relays, new computer and still when it is cold the truck won't start. We took it back again today. The dealer seems to be running out of options.   We are starting to think we truly have a lemon, any thoughts?   Thanks Donna Replies to this message: rangerhead94 (Jan 29, 2008 6:14 pm)

Messages Page 7 of 20 1 ... 4 5 6 7 8 9 10 ... 20 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums Pickups Ford Ranger Ford Ranger Starting Problems