Last post on Oct 03, 2013 at 4:57 PM
You are in the Ford Ranger
What is this discussion about?
Ford Ranger, Truck
#223 of 345 Another Ranger won't start
Jun 30, 2010 (5:44 pm)
I have a 1994 Ford Ranger XLT. I have been having problems for the last couple of years with it not starting. The engine doesn't turn over at all when keyed. I replaced the starter twice, which proved to be only a temporary fix. I also bought a new relay, and most times when it had trouble starting, simply pulling the relay would allow the truck to start. At this point, that is no longer working. I know that there has to be a bigger problem. I have considered replacing the entire relay box, but I am not sure if it will be a real solution. Any advice would be helpful.
#224 of 345 Another 94 Ranger 3.0 With No Spark
Jul 03, 2010 (2:22 pm)
After the truck ran for a while an i shut it off it would take hours to get it running again. This went on for weeks and now it wont start at all, im getting no spark. The coils fine and ive replaced the distributor. Ive been told to replace the crankshaft sensor but it doesnt have one, also to check the fuel relay but this has nothin to do with spark. Any advice
#225 of 345 ranger won't start
Jul 10, 2010 (6:00 am)
got in my 98 ranger last night and it no longer starts. when i turn the key it makes a loud clicking sound, but no engine noise at all. figured it was the battery or alternator, but the lights and everything else work just fine. what could this be?
#226 of 345 94 ford ranger starting problems
Jul 10, 2010 (9:14 pm)
I have a 94 ford ranger 2.3 liter, just put a new fuel pump, filter, rebuilt the engine so every thing is new, new crank sensor, ecu, and ignition control module. it cranks, wants to fire but wont start, any suggestions?
#227 of 345 Re: ranger won't start [matchbook]
Jul 10, 2010 (9:39 pm)
Check for corroded cables. Poke around, it might be under the insulation near the ends.
#228 of 345 94 ford ranger starting problems
Jul 12, 2010 (8:07 am)
I put in some injectors from a truck i bought for parts, it started right up after that, it ran all day yesterday, then it stopped running and now when i want to start it, it just backfires like a friggin 12 gauge shotgun
#229 of 345 93 ford ranger3.0/starting
Aug 18, 2010 (6:33 am)
1993 ranger only starts by pumping pedal 5 time while turning key,have to let warm up,when pushing in clutch runs very rough.after a few mins it's ok.after turning off,it takes several times to get started again.has to cool down. HAS NEW FUEL ASSY..NEW PLUGS AND WIRES,NEW ROTER UNDER DIST.CAP,TSP VALVE,AIR CONTROL VALVE,FUEL FILTER......
#230 of 345 Re: 93 ford ranger3.0/starting [whisperinggeo]
Aug 18, 2010 (3:54 pm)
Wild guesses - A leaking injector/s lets one/more cylinders fill up with gas after a shutdown.
-Leaking fuel pressure regulator lets vacumn line fill up with gas after shutdown and this causes hard starting.
#231 of 345 only 1 coil is working. but i know they are both good.
Aug 30, 2010 (7:50 pm)
i have an '89 ford ranger 4 cylinder, with 8 spark plugs, it looks like the crank sensor has been replaced and the module before the coils has been replaced. both of the coils are good but only one side gets spark. all of the fuses are good. i was wondering where i should look for a bad ground? and where the "E.E.C." sensor or something like that is located? please help me out. thank you.
#232 of 345 Re: only 1 coil is working. but i know they are both good. [89rangerdanger]
Aug 31, 2010 (9:43 am)
there is an ecc relay in the fuse box under the hood,your fuel relay is also in the same box.