Sign In Join 



Ford Ranger Starting Problems

187 messages,  Last post on Oct 27, 2009 at 6:32 AM

You are in the Ford Ranger Forum. Your Host is kcram

What is this discussion about? Ford Ranger, Truck


Messages Page 17 of 20
1
...
14
15
16
17
18
19
20
Prev
Next
Last
Go To Msg #
Search This Discussion

#156 of 187
98 ranger starting issues by freezejc73
Jun 02, 2009 (2:38 pm)
Reply
I have a 98 ranger with the 2.5l. When trying to to start it all i get is a click sound. I pulled the starter off and had it tested. The said it was locked up. I put a new starter on and get the same thing. Just a clicking sound. My battery is fully charged. Is it possible for the replacement starter to be bad? If not are there any other ideas on where to look?
#157 of 187
Spontaneous starting by ngrover
Jun 15, 2009 (1:38 am)
Reply
My two wheel drive Ranger's starter died. We put a new starter in it and since then it has twice spontaneously started while in gear (both reverse and 1st) and drove itself into a tree and kept on running, digging one of its rear wheels into the ground up to the axel before the car finally died. It does not have a remote starter in it. Has anyone ever heard of such a thing? Could it possibly be the new starter? I have it sold but I don't dare to give it to the new owner until I can fugure this out.
#158 of 187
ok cranking no spark by ironman9
Jun 21, 2009 (6:17 pm)
Reply
94 ranger 3.0 v-6 drive for a while then shut off no spark wait ten minutes it starts intermite problem but put test light on coil both terminals light stays on even while cranking replaced control module (mounted on radiator support) no diffrence i do believe if you tap on power distribution box it seems to start any help thank-you
#159 of 187
Re: 94 Ranger Starting Problems [ranger_driver] by jsilver19
Jun 22, 2009 (10:37 am)
Reply

Replying to: ranger_driver (Jun 02, 2009 3:19 pm)

I was having the same problem and could not figure it out for nothing. The problem is the crankshaft position sensor. It doesn't cost much and it will fix your problem. This sensor send a singal to the coil and fuel injection saying to work and not to work. Good luck.
#160 of 187
Re: ok cranking no spark [ironman9] by jsilver19
Jun 22, 2009 (10:38 am)
Reply

Replying to: ironman9 (Jun 21, 2009 6:17 pm)

I was having the same problem and could not figure it out for nothing. The problem is the crankshaft position sensor. It doesn't cost much and it will fix your problem. This sensor send a singal to the coil and fuel injection saying to work and not to work. Good luck.
#161 of 187
Re: ford ranger won't start sometimes??? [caluch] by wrangergirl
Jun 27, 2009 (2:27 pm)
Reply

Replying to: caluch (Apr 29, 2009 8:44 am)

I have the same problem at first I thought it was my battery, starter, or alternator. Someone did suggest the sensor or fuel pump. My catalytic converter is fine as far as I know. I got my truck checked and nothing wrong with my starter, alternator or battery. So its the sensor? I have a 95 Ranger and it only happens when its hot out. Below 82 no problems. What causes the hesitation? So what is the problem when its hot it wont start or it'll start and die. I have to let it sit for a couple hours than it starts right up like nothing is wrong.
#162 of 187
wont start by 02edge3l4x4
Jun 30, 2009 (10:28 pm)
Reply
i have a 2002 ranger 3.0l 4x4 edge standard cab 5 spd. so with the key on i have power, the fuel pump starts and everything works.... then when i turn the key farther to start it something clicks and the power turns off like the battery is dead.... i tried jumping it, no success. i tried popping the clutch and it works. so i have fuel, spark, and air. but something happens when i turn the key. i am lost. what would cause the car to not turn over and kill all power when i turn the ignition from on to start?
 
i am mechanically inclined, worked on cars a lot, but am at a complete loss and have no idea whats going on. if you have any advice please let me know.
#163 of 187
95 Ranger doesn't start by rangerboy
Jul 02, 2009 (7:39 pm)
Reply
My truck ran and started fine all day. Took the wife to the tanning store tonight and it will just click with nothing??? I have noticed my positive cable getting corroded and I've cleaned it a lot lately. When I keep turning the key it will click and my door locks will engage and disengage??? Is this an anti theft issue? I've tried arcing across the solonoid with a screwdriver. The battery is new.
#164 of 187
Re: 95 Ranger doesn't start [rangerboy] by rangerboy
Jul 04, 2009 (12:16 pm)
Reply

Replying to: rangerboy (Jul 02, 2009 7:39 pm)

I started out the negative cable needed a new connector. Then I swapped all the relays around in the power distribution box. Still nothing. Guy at the Autozone said there might be some more relays underneath the dash. I found them and swapped them around and got nothing! I got to looking at the starter relay and figured it would be easy to change so I changed it. The truck still wouldn't start. I found my remote and changed the batteries to try and mess with the alarm system. I would hit the panic button and lock and unlock the doors. Next, I decided that I would tackle the starter since there is nothing open this weekend. Well, I finally got it off and had it tested. It failed! I put the new starter in and it fired right up!
#165 of 187
1994 ford ranger by abunoon
Jul 06, 2009 (10:06 am)
Reply
My ranger was sputtering and it finally cut off. Now it wont start. it tries but wont turn over. I flipped the reset switch. any suggestions.

Messages Page 17 of 20
1
...
14
15
16
17
18
19
20
Prev
Next
Last
Go To Msg #
Search This Discussion
To POST a message, please Sign In.

New? Join Now!

Forum Tools

Please sign in.
Email Address:

Password:

Forgot Password?

Search Forums

Enter Keyword(s)

Advanced Search

Browse by Vehicle



View All Vehicles
Advertisement
Ask the Community
See What People Are Asking

Browse by Board

Browse by Topic


View All Topics

Today's Chats

Advertisement