You are here:
Forums
Pickups
Ford Ranger
Ford Ranger Starting Problems

188 messages, Last post on Nov 14, 2009 at 2:23 PM
You are in the Ford Ranger Forum. Your Host is kcram
|
|
|---|---|
|
My son has a 1989 ford ranger 4x4 4cyc., it will not turn over.My son figured out if you put some serious pressure on brake pedal it will turn over and start? I cant figure out what is causing this could someone please advise me where to start looking? Thanks, Jakes Dad Gregg Azevedo |
|
|
After driving 5 to 10 miles the engine will just quit and there is no spark but then after resting for an hour or 2 it will start and run. It always cranks over but has no spark. I have replaced the distributor module but after reading on the site I am wondering if it could be EEC relay? And what is that? Thank you your help! Really appreciate it. Chris |
|
| I recently had problems with my 1995 Ranger XLT where it would stop running all at once even while driving. After finaly getting it started and had the check engine light checked and found that the Crank Position Sensor was faulty. After replacing the Crank Sensor the truck ran great until a few days ago when after starting the engine it stopped after about a minute and now i can't get it started again. Any ideas on what might be wrong? I've also tried to locate the Ignition Control Module with no luck in locating it. Any help on where this is located? Thanks | |
| How can i tell when my question has been answered? | |
|
Replying to: joray (Jun 06, 2006 4:10 pm) |
|
| I have a 1993 ford ranger 4.0 4x4 my problem is that the starter is staying engaged. When all of this first started is when I replaced my alternator and battery, then my charging light stayed on so then I replaced the alt fuse under the hood. The truck started up but then after a few starts the starter is staying engaged. I have replaced the starter the starter relay and ignition switch on the steering wheel I checked all the wires and they all look good and am still having the same problem. Does any one have any tips on what I need to do to get it working. | |
|
Replying to: joray (Jun 06, 2006 4:10 pm)
|
|
|
Replying to: smokee1 (Dec 24, 2008 5:29 pm) --try beating the hell out of the converter..i knocked the clog loose on a minivan--big cloud of black dust came out of the tailpipe,and then it ran SWEET!! --if that gets it going,change the o2 sensor,put good-premium gas in it,then take it for a L O N G cruise kicking it down every now and again-once it's hot(operating temp),then,quit "babying" it..thicker oil,and most any car will last longer !! |
|
|
|
| 92 ford ranger won't start. last time it ran the starter stayed engaged and then it died and i jump started it and then it ran when i turned it off it died and wouldn't start back up. We changed the starter, sillinoid, ignition starter switch, key ignition switch and it still won't start. It isn't even turning over. I don't know what else to try. Please hep | |
|
Replying to: joray (Jun 06, 2006 4:10 pm) |
|
You are here:
Forums
Pickups
Ford Ranger
Ford Ranger Starting Problems
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2010 Ford Ranger



Browse by Board
Browse by Topic
Today's Chats