You are here: Forums Pickups Chevrolet Silverado & GMC Sierra Chevy Silverado and GMC Sierra Interior and Dashboard

Chevy Silverado and GMC Sierra Interior and Dashboard

156 messages,  Last post on Nov 05, 2009 at 12:38 AM

You are in the Chevrolet Silverado & GMC Sierra Forum. Your Host is kcram

What is this discussion about? Chevrolet C/K 1500 Series, Interior, Truck

Messages Page 9 of 17 1 ... 6 7 8 9 10 11 12 ... 17 Prev Next Last

Go To Msg # Search This Discussion

#72 of 156 Instrument Panel Cluster repair by bigz04 Dec 19, 2007 (5:20 pm)
04 Chevy. I'm on my 3rd Cluster this month! with no change. My Speedo still goes crazy at times or stays at zero. Plus the last repair on cluster the Truck's gear selector panel did not work, just have a blank screen. dealership keeps telling me that its the cluster and that they will keep ordering a new cluster until they get one that works! All fine and good but they keep my truck for half the day every time it goes in! Any one else have this same problem?????? My fear is that my local Chevy dealer don't know what they are doing on this repair.....
#73 of 156 Dashboard needs replacing by caseyboy87 Dec 22, 2007 (7:10 am)
For some reason the my dashboard directly underneath the windshield on the passenger side began to bubble and peel. Anyone know where I can get a new dash piece or somethine to replace it? Any help would be greatly appreciated.   Casey
#74 of 156 5.8 vortec motor miss by jerryk2 Dec 22, 2007 (7:26 pm)
when the motor is running at idle speed the rpm s go from like 800 to 300 or 400 and just jumps around only at idle speed and i have changed out both o2 sensors be for the converter so if you have any idea let me know i have not check the spark plugs yet and that is next for me to atleaset look at but the code off the service motor light says o2 sensors Replies to this message: muscleheader (Feb 02, 2008 7:49 am)
#75 of 156 Re: Headrest removal [mike239] by mike239 Jan 02, 2008 (1:42 pm)
Replying to: mike239 (Dec 16, 2007 12:12 pm) to remove the headrests there is a little hole on the side without the button if you push a paper clip into the hole and lift the headrest will come out
#76 of 156 Need some advice on Speedo/Speed sensors by bigz04 Jan 16, 2008 (8:43 am)
Okay I've had 5 yes 5 instrument panel clusters put in at my local "Parts changer" on my 2004 Z71 4x4 5.3L V8 with no luck in fixing my Speedo that only wants to work some times, half the time it will stay at zero or bounce from current speed to a lower speed. I plan on taking out my Speed Sensors in the Transfer case and cleaning them with some electric parts cleaner to see if that works, other wise its $80 for two new ones? Any one else do this repair before or have the same speedo issue? Am I going to have fluid from the transfer case come out when I un-blot these speed sensors?
#77 of 156 instrument panel by edh6207 Jan 26, 2008 (5:17 pm)
For the last 3 days. my instrument panel has been flash. it will go from security, low fuel, and battery. does anyone know the cause of this. Replies to this message: szymas (Jul 10, 2009 8:40 am)
#78 of 156 Re: 5.8 vortec motor miss [jerryk2] by muscleheader Feb 02, 2008 (7:49 am)
Replying to: jerryk2 (Dec 22, 2007 7:26 pm) Jerryk2 there are 2 more O2 sensors there. If the read out keeps saying that then replace the othere two. there are 2 behind the cat and two above the cat. usualy on the the exhaust manifolds
#79 of 156 Re: Heated seat inop. [engine103] by kiernan_2001 Feb 04, 2008 (1:21 pm)
Replying to: engine103 (Feb 01, 2007 8:57 pm) I am having the same problem at about the same mileage... Does anyone know how to fix this. The passenger side works, but the driver side does not. It turns on, but then shuts off within seconds.
#80 of 156 Wet carpet by 04gmcsierra Feb 09, 2008 (8:56 pm)
I have an 04 GMC Sierra Extended Cab, and every time I wash my truck the carpet on the passenger side in the front is soaked. The carpet is wet under the plastic trim and about 2 inches beyond. No wind noise when I drive the truck. Replaced the door seal, but no luck. I have had some one inside the truck when I spray the door with water and they say that they do not see any water running from the top of the door nor the sides of the door. Is there any way it could my getting in from the engine compartment? If not possibly were? Please help, Replies to this message: dmcgee (Mar 24, 2008 5:08 pm) kc1371 (Apr 15, 2008 7:05 pm) cleslie2006 (May 31, 2008 6:16 pm)
#81 of 156 can i put 1998 or 2003 seats in a 1996 gmc sierra by iwaswundering Mar 18, 2008 (11:11 am)
I just recently purchased a 1996 gmc sierra, and the front seats are all worn out. it is the basic SL model with the 60/40 bench. I want to install a newer seat which has the middle fold down console which can fold back up into a seat, along with the reclining feature. As mine is the striaght bench right across with out any of these features. I was wondering how newer of a seat can i install into the cab, as to i have a bad back and would like to get the most recently designed seat chevy makes as possible egronimically wise. I was told by a dealer 96 to 98 truck seats are compatible, and by a auto wrecking yard 88-98 all truck seats are compatiable. Is there any chance that a 03 or even a 02 seat would be able to fit in this truck because i have recently sat in one and those seats are very comfortable. anyones input on this matter would be greatly much appreciated because my truck is going to be out of the shop next week and the hunt for a better seat will begin thank you for your time.

Messages Page 9 of 17 1 ... 6 7 8 9 10 11 12 ... 17 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums Pickups Chevrolet Silverado & GMC Sierra Chevy Silverado and GMC Sierra Interior and Dashboard