You are here: Forums Pickups Nissan Frontier Nissan Frontier Maintenance and Repair

Nissan Frontier Maintenance and Repair

60 messages,  Last post on Aug 01, 2009 at 8:05 AM

You are in the Nissan Frontier Forum. Your Host is kcram

What is this discussion about? Nissan Frontier, Truck

Messages Page 3 of 7 1 2 3 4 5 6 7 Prev Next Last

Go To Msg # Search This Discussion

#15 of 60 Re: check engine light after installing k&n cai and throttle body spacer [badfireguy] by asa Nov 17, 2007 (6:03 am)
Replying to: badfireguy (Nov 16, 2007 6:44 pm) Great fix badfireguy! Very clever and successful as far as performance too. Happy Motoring!
#16 of 60 Frontier Frontend troubles.. by ryan82 Nov 23, 2007 (4:07 pm)
I currently own a 1999 nissan frontier.. There barely any travel in the front suspension with out it bottoming out.. The rear of the truck sits much higher than the front.. 61/2 in from top of the wheel to the bottom of the wheel well.. compared to the 21/2 in in the front.. how is this fixed? Any suggestions would be helpful..   Thanks  Ryan82 Replies to this message: badfireguy (Nov 23, 2007 11:19 pm) asa (Nov 25, 2007 6:39 am) asa (Nov 26, 2007 12:10 pm)
#17 of 60 Re: Frontier Frontend troubles.. [ryan82] by badfireguy Nov 23, 2007 (11:19 pm)
Replying to: ryan82 (Nov 23, 2007 4:07 pm) The first thing I would do is change the front shocks. My favorite is the Monroe Reflex. an excellent shock that sells for about $45.00 each. It should raise the front end and will last forever. I'm guessing that you do not carry any weight in the bed, because the frontier does not have much spring in the rear. Adding a little weight to the rear will not only lower the level more than you would think, but will actually make the truck handle a little better and give you much more traction.   Good Luck! Replies to this message: asa (Nov 25, 2007 6:39 am)
#18 of 60 Re: Frontier Frontend troubles.. [badfireguy] by asa Nov 25, 2007 (6:39 am)
Replying to: badfireguy (Nov 23, 2007 11:19 pm) My favorite is the Monroe Reflex.   I second that. I put Monroe struts on my '92 Mitsu six months ago and the improvement in handling is phenominal. It's not a bad d-i-y job and I'm nothing more than an amateur weekend wrench. I "rented" spring compressors (for free) at Advance Auto. I also have the factory service manual and it was a help.   I'm assuming that the springs are up to specification? They might be weak. I recall seeing an entire assembled strut/spring package ready for installation, perhaps made by Monroe. This'd make the job VERY easy and would give you new springs too.
#19 of 60 Re: Frontier Frontend troubles.. [ryan82] by asa Nov 26, 2007 (12:10 pm)
Replying to: ryan82 (Nov 23, 2007 4:07 pm) If you have a 4x4, I should have suggested too that you check your torsion bars. If they're tired, your front will sag. These can also be cranked to elevate the front and /or change the spring rate. I've never had a 4x4 so can't give you more guidance on this.
#20 of 60 What model frontier is it? by badfireguy Nov 26, 2007 (5:34 pm)
Good point! It sounds like a 4cyl. 2wd truck. My last frontier (99 model) needed helwig springs and Rancho RS9000 shocks to fix the problem. So, Ryan what kind of truck to you have?
#21 of 60 2001 Nissan XE Pick -up by wingsovgrace Nov 28, 2007 (7:02 pm)
Instrument panel guages are not registering. Once in a while they will work correctly but it's just for a few minutes then the needles begin jumping around again. Everything else is working properly (i.e. lights, heater, radio, etc.) I would appreciate suggestions for troubleshooting or perhaps a wiring guide. Anything that might help is appreciated. Thanks
#22 of 60 Instrument panel gremlins by badfireguy Nov 28, 2007 (11:36 pm)
I'm going out on a limb here, but the first two things that come to my mind are: 1. check the connection from the wiring harness to the main instrument cluster. I have seen the ribbon wiring wear and lose connectivity.   2. Would you happen to have an aftermarket stereo installed in the dash? I hate to think that an installer would use the first power wire that they came across, but........I think you know where this is going. Any nick in the insulation of the wiring can and will cause a short anytime that it touches metal.   However, I happen to have the entire wiring diagram for my 2004 desert runner that I bought online. It is extremely accurate, and I would be happy to email it to you if you like. I really think that you are going to need a good multi meter and a lot of time to find the problem. Let me know if you would like the electrical schematics, I will be happy to send them to you free of charge.
#23 of 60 2001 Nissan XE Pick -up by wingsovgrace Nov 29, 2007 (5:57 am)
Instrument panel guages are not registering. Once in a while they will work correctly but it's just for a few minutes then the needles begin jumping around again. Everything else is working properly (i.e. lights, heater, radio, etc.) I would appreciate suggestions for troubleshooting or perhaps a wiring guide. Anything that might help is appreciated. Thanks
#24 of 60 electrics on a Frontier 2003 by tobyj Nov 29, 2007 (10:27 am)
Hello! Recently, my 4 x 4 frontier electrics went wonky. The fuse for the dome and interior lights kept blowing, and now the Door Open sign is on ALL the time. The inside lights still don't work. I am woried that at some point, all my electrics will short out. Any ideas, anyone? Thanks Toby surtobygmail.com

Messages Page 3 of 7 1 2 3 4 5 6 7 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums Pickups Nissan Frontier Nissan Frontier Maintenance and Repair