Ask the Car People.SM


Ford Ranger Engine questions

302 messages,  Last post on Mar 04, 2013 at 12:21 AM

You are in the Ford Ranger Forum.

What is this discussion about? Ford Ranger, Truck

Messages Page 29 of 31

#281 of 302 Re: 4.0 L V6 Just quit while going 55 mph. Won't start [baseballdawg] by airborne3006

Oct 21, 2010 (7:40 pm)

Replying to: baseballdawg (Oct 20, 2010 9:34 pm)
what do you mean by it won't? Will it turn over at all? Does it have fire? Try taking off valve cap on fuel rail and see if there is any fuel in there as there should. Also check the fuel pump if no fuel is there.

#282 of 302 Re: 4.0 L V6 Just quit while going 55 mph. Won't start [airborne3006] by bolivar

Oct 21, 2010 (10:25 pm)

Replying to: airborne3006 (Oct 21, 2010 7:40 pm)
1)There are relays on/under/beside the fuse box under the hood. One of the relays is for the fuel pump. If relay is bad, fuel pump doesn't work.
 
2)Inside, on the right side of the 'hump', at the top, just under the edge of the carpet is a 'rollover' relay. (If truck rolls over, this will stop the fuel pump.) It has a button on it for reset. If the truck hit a huge bump in the road, it might have triggered this switch. It's wiring could also be bad.
 
3)Fuel pump died. It's inside the fuel tank.
 
4)Dozens of other things.

#283 of 302 Re: 1993 Ford Ranger engine modifications question [airborne3006] by leblanc500

Nov 05, 2010 (7:20 am)

Replying to: airborne3006 (Aug 19, 2010 5:32 pm)
i have a 1993 ford ranger 4X4 can I change the engine from 4L OHV to another more recent engine. I am looking for the easiest solution. Will the airbox have to be moved. I have a 4" lift. Thank you

#284 of 302 Re: hard starting and rough idle 2002 3.0l [rbd008] by pdcjhonda

Nov 07, 2010 (11:17 am)

Replying to: rbd008 (Jun 10, 2008 11:35 am)
What did you have to do to get this fixed?

#285 of 302 engine swap 1983 ranger 4x4 2.8 v-6 manual trans by scottk1

Dec 05, 2010 (6:34 pm)

Does anyone know what other carberated or throttle body type early v-6 engines will bolt up to the existing bell housing on this 2.8 v-6 truck? I want to get rid of the 2.8 v-6 i have and rebuild another v-6 to put in. any info on motors for this swap will be greatly appreciated.

#286 of 302 Re: exhaust [bolivar] by oranger

Feb 06, 2011 (10:17 am)

Replying to: bolivar (Mar 25, 2007 7:54 pm)
Just because it's a four banger doesn't mean its a good as it gets, any truck can get better mileage with tuning. Less restrictive intake and exhaust,kept in tune ,synthetic oil and even tire pressure can change mileage.I have a 1991 2.3 L that has K&N filter, port matched intake and exhaust, 2.5 inch exhaust, Amsoil synthetic oil and BFG radial TAs, It started at 18-20 mpg now it runs at 38 mpg with a substantial power gain.
No factory vehicle is as good as it gets, its as good as they can make quickly and cheaply.

#287 of 302 1994 Ranger 2.3L 8 plug head by fortee9er

Sep 18, 2011 (8:05 pm)

#288 of 302 1994 Ranger 2.3L 8 plug head by fortee9er

Sep 18, 2011 (8:05 pm)

My 1994 Ranger 2.3L 5spd with a 8 plug head is putting out code 224. The plugs on the exhaust side are not firing. We replaced the coil pack but it made no difference. Has anyone had this problem and what ws the cause. Otherwise tips on how to troubleshoot this problem would be greatly appreciated.
Thanks

#289 of 302 Engine trouble Check engine light by jgathers

Nov 25, 2011 (7:49 pm)

#290 of 302 Engine trouble Check engine light by jgathers

Nov 25, 2011 (7:49 pm)

I have a 1998 Ford ranger xlt. I had the head done and the engine ran hot and I had to have one head replaced again. Now the check engine light is on and when I start the truck I hear a series of 4 beeps. Sometimes while driving the 4 beeps come on again! I do not have an owners manual.
 
Bernie

Messages Page 29 of 31

To POST a message, please Sign In.

Advertisement

Browse by Category

Browse by Vehicle
   View All Vehicles

Browse by Board
Browse by Topic
View All Topics

Edmunds Community

Advertisement