Sign In Join 



Ford Ranger Engine questions

256 messages,  Last post on Dec 02, 2009 at 5:39 AM

You are in the Ford Ranger Forum. Your Host is kcram

What is this discussion about? Ford Ranger, Truck


Messages Page 22 of 26
1
...
19
20
21
22
23
24
25
26
Prev
Next
Last
Go To Msg #
Search This Discussion

#211 of 256
Re: ford torque specification [adenton] by lickity
Dec 12, 2008 (2:44 pm)
Reply

Replying to: adenton (Dec 12, 2008 1:49 pm)

19 - 28 foot pounds
#212 of 256
99 Ford Ranger--engine shakes by Rangergrl
Dec 28, 2008 (7:30 am)
Reply
My Ranger only has 38,000 miles on it, and when I sit idle (say at a stoplight) the engine shakes. The normal shaking does not bother me, but there is a definite whole engine shakes and it feels like a belt is loose/off but I'm not sure. Any ideas?
Thanks.
#213 of 256
Re: 99 Ford Ranger--engine shakes [Rangergrl] by grump1
Dec 28, 2008 (7:49 am)
Reply

Replying to: Rangergrl (Dec 28, 2008 7:30 am)

first of all , lift the hood up and check.
#214 of 256
engine shake by grump1
Dec 28, 2008 (7:50 am)
Reply
second of all, when have you tuned it up last..?
#215 of 256
Re: 99 Ford Ranger--engine shakes [Rangergrl] by grump1
Dec 28, 2008 (9:53 am)
Reply

Replying to: Rangergrl (Dec 28, 2008 7:30 am)

check your vacuum lines - see if any are off or cracked.
#216 of 256
89 ranger 2.3 engine by tnt40185
Dec 28, 2008 (11:32 am)
Reply
I just bought an 89 ford ranger with a 2.3 engine with 2 coil pacs. When I first drove it home it smoked for about 15 minutes and stoped smoking. It runs rough at an idle but when you increase the RPM's up to 1000 rpm's it smoothes out and there is no missing. I replaced the plugs and wires and it still misses at an idle but it smokes again and won't stop. It is a grey smoke. I did a pressure test on the coolant system and it shows a leak I think it is a head gasket. My question is if it is a head gasket and is repaired is the grey smoke going to go away or will it continue ? Also I understand it could be a bad cylinder. With running at a higher RPM's wouldn't it miss all the time if it is a bad cylinder. looking for a cheap fix
 
Terry
#217 of 256
89 for 2.3 by tnt40185
Dec 28, 2008 (11:55 am)
Reply
I was wrong on the RPM's on the previous post when I raise them up to 2000 RPM's its smooth. But it seems like its running rich also. Any help would be apreciated.
 
Terry
#218 of 256
89 ford 2.3 by tnt40185
Dec 28, 2008 (12:38 pm)
Reply
I just drove the ranger about 10 miles and the engine stopped smoking but it still misses at an idle. Is it possable that the cat converter is also causing me problems?
 
Terry
#219 of 256
twin plug head by pops13
Dec 31, 2008 (3:48 am)
Reply
can someone tell me why ford would put 8 plugs in a four cyl. motor? ang then they make the 4 on the drivers side almost impossible to get out. was this one of fords better ideas?
#220 of 256
1999 4cyl. power problem? by bugscout21
Dec 31, 2008 (3:08 pm)
Reply
My ranger 4 cyl with 168,000 miles runs perfect at speed but at low rpm it wants to stall. timing belt plugs and wires were just done and it started this after the wires and plugs????

Messages Page 22 of 26
1
...
19
20
21
22
23
24
25
26
Prev
Next
Last
Go To Msg #
Search This Discussion
To POST a message, please Sign In.

New? Join Now!

Forum Tools

Please sign in.
Email Address:

Password:

Forgot Password?

Search Forums

Enter Keyword(s)

Advanced Search

Browse by Vehicle



View All Vehicles
Advertisement
Ask the Community
See What People Are Asking

Browse by Board

Browse by Topic


View All Topics

Today's Chats

Advertisement