You are here:
Forums
SUVs
GMC Jimmy
GMC Jimmy 4WD Problems

200 messages, Last post on Nov 30, 2009 at 8:00 PM
You are in the GMC Jimmy Forum. Your Hosts are steve_ & tidester
|
Hi, My 4 wheel drive will not work on my 1995 GMC jimmy. Mechanic said it was the cable. I have no idea, so I go on the intenet and buy a ACDELCO US 15721261 Trans Shift Cable 4wd ; 4-speed At (m30) ; Chevrolet (x88) ; Gmc (z88); Years:1995-1996; Per Car Qty:1; from Bestvalueautoparts. You quessed it WRONG cable. My mechanic said the cable is about 18" to 24" long. Thats it no other info. Does any one here have an idea what cable I need and where to get it? Thnaks for any info Frank |
|
2000 gmc jimmy wont shift into 4 wheel lo high or auto...the lights on the push buttons just flash then kicks back into 2 wheel high...i dont have a clue can anyone help
|
|
|
Replying to: jesse (Nov 25, 2008 7:09 pm) |
|
|
Replying to: jesse (Nov 25, 2008 7:09 pm) |
|
|
i have a 1999 GMC Jimmy 4wd 4 door, i was driving to work when i heard a noise that was getting louder that the stereo. I turned the radio off and listened, at low speed say 10mph it is a clicking/grinding noise, if i put the vehicle in 4wd the noise imediatly stops, when i switch back from 4wd to 2wd decel, then acelerate again the noise comes back, if i go 20mph or more the noise becomes a loud howling sound that gets very loud on decel, but once again if i click 4wd the noise imediatly stops. about 4 days prior to this happening i replaced the heater core, although i don't think there is anything i did to disrupt anything to cause this problem. I did notice that when taking sharp turns in 4wd i heard a clicking sound, so i jumped the gun and replaced the cv shaft on the passenger side cause that is where the noise was, i no longer have that clicking noise although the original problem sound is still there just as bad as it was in the first place. i hear wheel bearings are an issue although i would believe that when puting the truck in 4wd i should still hear the sound. any ideas would be helpful? thanks Jon
|
|
|
Replying to: jbagz (Dec 07, 2008 3:55 pm) Only way to fix it is to replace the gear and also the nylon washer in your front differential. This problem can be caused by poor vacuum not pulling the cable all the way to fully engage or disengage the gear. once its burred it must be repaired. Also check to see if you have a vacuum problem. Just my 2 cents. I had the same symptoms as you and that was my fix.
|
|
|
Replying to: goodyguy (Dec 07, 2008 6:22 pm)
|
|
|
Replying to: jbagz (Dec 07, 2008 7:39 pm) The only thing inside the black housing is the connection for the cable. Parts cost was under $250.00 and labor was under $150.00 Unless you have a working knowledge of the differential and parts involved I wouldn't recommend doing it yourself. |
|
lite is on on 2wd , push other 2 buttons 4wd lites dont come on or ingage 4wds.Its not the cable under the battery. Is there a fuse that controls this? If so where is it located?
|
|
|
Replying to: emilie1 (Dec 09, 2008 8:37 pm) |
|
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2001 GMC Jimmy



Browse by Board
Browse by Topic
Today's Chats