Chrysler Town & Country: Starting/Stalling/Idling Problems

156 messages, Last post on Oct 09, 2009 at 7:02 AM

You are in the Chrysler Town & Country/Dodge Grand Caravan Forum. Your Host is Karens

What is this discussion about? Chrysler Town and Country, Chrysler, Engine, Van

Outline

Messages Page 17 of 17: 1; ...; 11; 12; 13; 14; 15; 16; 17; Prev; Next; Last

#155 of 156 Re: Chrysler [srs_49] by silky2003 Oct 08, 2009 (6:29 am)
Replying to: srs_49 (Oct 08, 2009 3:01 am) My Van Has 197,000 miles on it. It has a 3.3 V6 Engine. The engine cranks but will not start. It is not getting any spark. Like I said I change the coil pack, crank and cam sensors, Fuel Pump. The engine is getting fuel. I replaced Both PCM's but I replace them with used ones from the junk yard. Before I replaced both pcm's the van only had a problem with the starter. Replies to this message: srs_49 (Oct 09, 2009 7:02 am)
#156 of 156 Re: Chrysler [silky2003] by srs_49 Oct 09, 2009 (7:02 am)
Replying to: silky2003 (Oct 08, 2009 6:29 am) OK - thanks for the additional information. Unfortunately, I can't tell you where to go from here. I assume the PCM (ECU) is getting +12V? I had the 3.3L in our '94 DC, but never had any problems with the ignition, so never had to replace or troubleshoot the parts you've already replaced.

#155 of 156: Re: Chrysler [srs_49] by silky2003; Oct 08, 2009 (6:29 am)

Replying to: srs_49 (Oct 08, 2009 3:01 am)

My Van Has 197,000 miles on it. It has a 3.3 V6 Engine. The engine cranks but will not start. It is not getting any spark. Like I said I change the coil pack, crank and cam sensors, Fuel Pump. The engine is getting fuel. I replaced Both PCM's but I replace them with used ones from the junk yard. Before I replaced both pcm's the van only had a problem with the starter.

srs_49 (Oct 09, 2009 7:02 am)

#156 of 156: Re: Chrysler [silky2003] by srs_49; Oct 09, 2009 (7:02 am)

Replying to: silky2003 (Oct 08, 2009 6:29 am)

OK - thanks for the additional information.

Unfortunately, I can't tell you where to go from here. I assume the PCM (ECU) is getting +12V?

I had the 3.3L in our '94 DC, but never had any problems with the ignition, so never had to replace or troubleshoot the parts you've already replaced.