You are here: Forums Vans & Minivans Chrysler Town & Country/Dodge Grand Caravan Chrysler Town & Country: Starting/Stalling/Idling Problems

Chrysler Town & Country: Starting/Stalling/Idling Problems

156 messages,  Last post on Oct 09, 2009 at 7:02 AM

You are in the Chrysler Town & Country/Dodge Grand Caravan Forum. Your Host is Karens

What is this discussion about? Chrysler Town and Country, Chrysler, Engine, Van

Messages Page 13 of 17 1 ... 10 11 12 13 14 15 16 17 Prev Next Last

Go To Msg # Search This Discussion

#115 of 156 Re: 1999 Town and Country Starting issues instrument panel shut off [aka_oj [aka_ojay] by xwesx Nov 24, 2008 (9:23 am)
Replying to: aka_ojay (Nov 23, 2008 2:47 pm) OJ - there have been several posts on the solder issue; BCM has also been discussed once or twice since I have watched the discussions. I purchased a '98 DGC in May of 2007, and have watched the boards sporadically since then, so try searching messages within that time frame.   As I stated above, I have yet to address my cracked solder problem. It occurred rarely and for brief times until this September, when it went out for about two weeks before finally working again. Unfortunately, I was just too busy with other things then to deal with it. It tends to behave during the winter months, but once things warm up, it will likely become more temperamental.   I *think* the BCM is located on the firewall in the driver's footwell area. It is a black box with one large wiring harness connected to it.
#116 of 156 Re: 1999 Town and Country Starting issues instrument panel shut off [aka_ojay] by nukbuk Feb 16, 2009 (10:57 am)
Replying to: aka_ojay (Nov 15, 2008 10:49 am) I've been through the same issues with my 98T&C. Here is the link to the soldering slide show that fixed my problem http://photoshow.comcast.net/watch/uQ6gE3nV. Before I used this fix I had my cluster panel replaced at the dealership, but a week after they replaced it the car began to stall whenever I made a sharp right turn. Because I had them give me the old part, I was able to perform this fix myself.   I hope this works and if so, pass it on to other fourms.   Nukbuk Replies to this message: xwesx (Feb 16, 2009 11:41 am) srs_49 (Feb 16, 2009 3:13 pm) mismaili (Feb 16, 2009 7:12 pm) martyi (Mar 30, 2009 5:54 pm) xwesx (Apr 06, 2009 12:02 pm) mark3694 (Apr 27, 2009 6:42 pm) nukbuk (Apr 28, 2009 5:55 am) mark3694 (Apr 29, 2009 5:49 pm)
#117 of 156 Re: 1999 Town and Country Starting issues instrument panel shut off [nukbuk] by xwesx Feb 16, 2009 (11:41 am)
Replying to: nukbuk (Feb 16, 2009 10:57 am) Nukbuk - that show is fantastic! Thanks for sharing.
#118 of 156 Re: 1999 Town and Country Starting issues instrument panel shut off [nukbuk by srs_49 Feb 16, 2009 (3:13 pm)
Replying to: nukbuk (Feb 16, 2009 10:57 am) Though I hope I never have to pull the instrument cluster, your video should make it easier. Good job.
#119 of 156 Re: 1999 Town and Country Starting issues instrument panel shut off [nukbuk] by mismaili Feb 16, 2009 (7:12 pm)
Replying to: nukbuk (Feb 16, 2009 10:57 am) Hey Nukbuk, that was an excellent recap, well documented video on the starting resolution. I solved my starting problem with a new circuit board. Now, I wished I had seen this video before buying the new board. Anyway, my issue has been resolved and hope everyone else out there can learn from this as well. regards,   Miz
#120 of 156 Re: 2003 T&C stalling and running rough [marty29] by ecurveman Feb 18, 2009 (7:03 am)
Replying to: marty29 (Oct 15, 2008 10:29 pm) do a vaccum test
#121 of 156 2007 stalling without warning by sutphindg Mar 03, 2009 (2:25 pm)
I have a 2007 T&C. Twice in the past week it has stalled without warning while I was driving, both times putting me at risk of serious danger. The dealer can't find anything. I read a blog regarding an earlier model suggesting the keys were too heavy, causing the car to turn off slightly, but I don't have any new keys on my ring. Anyone else have this problem or any thoughts? Replies to this message: srs_49 (Mar 04, 2009 4:55 am) sutphindg (Mar 11, 2009 10:48 am) joepeterson56 (Mar 11, 2009 11:05 am) srs_49 (Mar 11, 2009 12:51 pm) and 1 more...
#122 of 156 Re: 2007 stalling without warning [sutphindg] by srs_49 Mar 04, 2009 (4:55 am)
Replying to: sutphindg (Mar 03, 2009 2:25 pm) I have a 2007 Grand Caravan, and have never experienced your problem.   When it cuts out, do all the warning lights on the dash come on , meaning the engine had really died? Replies to this message: sutphindg (Mar 11, 2009 10:48 am) joepeterson56 (Mar 11, 2009 11:05 am) srs_49 (Mar 11, 2009 12:51 pm) aka_ojay (Mar 24, 2009 2:40 pm)
#123 of 156 Re: 2003 T&C stalling and running rough [mjparisi] by roeteena Mar 05, 2009 (8:11 am)
Replying to: mjparisi (Oct 20, 2008 12:07 pm) I am more than ready for a lawsuit,just keep me informed.
#124 of 156 Re: 2007 stalling without warning [srs_49] by sutphindg Mar 11, 2009 (10:48 am)
Replying to: srs_49 (Mar 04, 2009 4:55 am) No lights come on. The dash is blank and the car is off. I coast to the side of the road, turn the key to the off position then turn it back on and it starts. Replies to this message: joepeterson56 (Mar 11, 2009 11:05 am) srs_49 (Mar 11, 2009 12:51 pm) aka_ojay (Mar 24, 2009 2:40 pm)

Messages Page 13 of 17 1 ... 10 11 12 13 14 15 16 17 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums Vans & Minivans Chrysler Town & Country/Dodge Grand Caravan Chrysler Town & Country: Starting/Stalling/Idling Problems