Edmunds.com | Inside Line | Auto Observer Your Account | Help | Directory
You are here:
![[F]](http://a332.g.akamai.net/f/332/936/12h/www.edmunds.com/media/townhall/webxicons/site.gif){kind=small}
Forums
Vans & Minivans Chrysler Town & Country/Dodge Grand Caravan Chrysler Town & Country: Starting/Stalling/Idling Problems
156 messages, Last post on Oct 09, 2009 at 7:02 AM
You are in the Chrysler Town & Country/Dodge Grand Caravan Forum. Your Host is Karens
|
Replying to: aka_ojay (Nov 15, 2008 12:00 pm) Last night parked the van in the garage so no moisture...Van started right away. On the way to work today the Door locks acted up. While driving the "Door Open" light flickered on and off along with the door locks.... So now all of a sudden the van is possesed
|
|
|
Replying to: aka_ojay (Nov 16, 2008 10:25 am) Part of the problem you are describing (instrument panel going out) sounds like it is the broken solder issue. But, I am not sure that the solder problem causes no-start situations or other electrical oddities, like the blinker and door locks. At least, no such problems with my van, which clearly does have a solder issue. I think it may be a combination of the solder problem and a problem with the Body Control Module (BCM). Neither of those things should wreak havoc on your transmission's ability to shift.... |
|
|
Thanks xwesx! Did you or someone else post any info on the BCM or solder issue? If you did can you send me the link to it so I can read it again? Where is the BCM located? Thanks OJ
|
|
|
Replying to: aka_ojay (Nov 23, 2008 2:47 pm) As I stated above, I have yet to address my cracked solder problem. It occurred rarely and for brief times until this September, when it went out for about two weeks before finally working again. Unfortunately, I was just too busy with other things then to deal with it. It tends to behave during the winter months, but once things warm up, it will likely become more temperamental. I *think* the BCM is located on the firewall in the driver's footwell area. It is a black box with one large wiring harness connected to it. |
|
|
Replying to: aka_ojay (Nov 15, 2008 10:49 am) I hope this works and if so, pass it on to other fourms. Nukbuk |
|
|
Replying to: nukbuk (Feb 16, 2009 10:57 am) |
|
|
Replying to: nukbuk (Feb 16, 2009 10:57 am) |
|
|
Replying to: nukbuk (Feb 16, 2009 10:57 am) regards, Miz |
|
|
Replying to: marty29 (Oct 15, 2008 10:29 pm) |
|
I have a 2007 T&C. Twice in the past week it has stalled without warning while I was driving, both times putting me at risk of serious danger. The dealer can't find anything. I read a blog regarding an earlier model suggesting the keys were too heavy, causing the car to turn off slightly, but I don't have any new keys on my ring. Anyone else have this problem or any thoughts?
|
|
You are here:
Forums
Vans & Minivans Chrysler Town & Country/Dodge Grand Caravan Chrysler Town & Country: Starting/Stalling/Idling Problems
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2010 Chrysler Town and Country
Browse by Board
Browse by Topic
