You are here:
Forums
Pickups
Dodge Dakota
Dodge Dakota Transmission Problems

696 messages, Last post on Dec 05, 2009 at 5:03 AM
You are in the Dodge Dakota Forum. Your Host is kcram
I have a 95 dakota with a 5.2 and automatic. I just bought it and the trans had just been rebuilt but the guy still had problems with it. I got it home and the throttle valve cable wasn't connected. So I put a new cable on it and changed the trans fluid because it looked dirty. Now it shifts fine but when you come to a stop it will not shift back into 1st by itself. You can do it manually but it won't do it by itself. Any help would be appreciated.
|
|
|
Replying to: jer7rob (Aug 01, 2009 2:19 pm) Thank you for any suggestions.... |
|
|
Replying to: pbell26 (Aug 01, 2009 2:42 pm) |
|
|
Replying to: hfcuda (Jul 18, 2009 8:54 pm) |
|
|
I have a 06 Dak quad cab 3.7L V6 automatic. I purchased it with about 20,000 miles. I now have 39,000 miles on it now and of course there is something wrong. When I first purchased the truck I noticed that it had some power issues. It didn't seem like it was running correctly at all. It had no power. Now, the check engine light is on and after a few miles of driving the temp light comes on. I took it to AAMCO and they said that 5 different codes were coming up and more than likely I need to replace the transmission. It doesn't feel like the transmission is slipping although I do see some hesitation with it going into gear when I first start it up. AAMCO wants to charge about $1,800 and I was wondering if there is something else I could try first. I mean, I don't abuse the thing at all! I run it pretty slow and I never mistreat the thing. i drive it to work and back on the interstate about 30 min a day.. Please Help!!!!!!!!
|
|
|
Replying to: cmitter99 (Aug 04, 2009 11:42 am) |
|
|
Replying to: travis1488 (Jul 18, 2009 11:15 am) |
|
|
Replying to: pedm (Jul 07, 2009 12:29 pm) "The trans will only operate in 2nd and 3rd".High gear starts usually is a bad governor pressure solinoid.No upshift from first is usually a governor pressure sensor.As far as changing the plug it comes as one piece with the internal wire harness and the overdrive cancel and TCC solinoid.It is not very hard to replace.First you drop the valve body.You may have to turn the drive shaft slightly to remove thr park pawl shaft{and to reinstall it}I have found its easier to leave the park rod on the valve body rather than try to mess with the E clip holding it on.Once the valve body is down you will need a 25 torx bit to remove the internal harness assembaly. |
|
2002 dodge dakota with 4.7 auto. Just recently the torque converter has started to unlock and lock once the truck is warmed up and driving at a smooth crusing speed. The tack will jump from about 1800 to 1900 . I have found lots of people with the excat same simptoms, but have not found any answers. Can someone help? Thanks.
|
|
You are here:
Forums
Pickups
Dodge Dakota
Dodge Dakota Transmission Problems
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2010 Dodge Dakota



Browse by Board
Browse by Topic
Today's Chats