Sign In Join 



Dodge Dakota Transmission Problems

694 messages,  Last post on Dec 03, 2009 at 7:32 AM

You are in the Dodge Dakota Forum. Your Host is kcram

What is this discussion about? Dodge Dakota, Truck


Messages Page 64 of 70
1
...
61
62
63
64
65
66
67
...
70
Prev
Next
Last
Go To Msg #
Search This Discussion

#626 of 694
Re: Dakota shift solenoid problem? [rbentsen] by pedm
Jul 07, 2009 (6:10 pm)
Reply

Replying to: rbentsen (Jul 07, 2009 6:07 pm)

Can you tell me the exact location of the electrical connection on the transmission you are speaking of. The only one I could see was on the driver's side and was a three wire ( I think) connection). Right above it was what looked like the shifter cable.
Thanks,
Paul
#627 of 694
Vibration around transfer case after 60mph by bhyman1
Jul 09, 2009 (7:23 am)
Reply
Hello:
 
I have a 4x4 1989 Dodge Dakota 3.9L V6. Recently, I have been experiencing a loud whizzing/vibration noise around my transfer case which only occurs from 60mph and up. The engine and transmission both seem to be running fine, but I was just concerned about the noise from the transfer case.
 
Just as an added note, when I move the transfer shifter up just a tad at the 2WD position, the noise becomes higher pitched.
 
Thanks
#628 of 694
Re: Dakota shift solenoid problem? [pedm] by rbentsen
Jul 09, 2009 (12:40 pm)
Reply

Replying to: pedm (Jul 07, 2009 6:10 pm)

You are probably referring to the shaft speed sensor, which will cause the speedo to go out if it is defective.The connector I am referring to is on the driver's side toward the front of the transmission. It is a round plug with 8 pins inside. It is not easy to get to. That is why I had a transmission shop change the connector once I found out where the problem was. They actually cut the male portion of the plug and used butt-splices to wire in the new plug. The Chilton manual shows 9 wires going from the PCM to the transmission, so I know there is more than just 3.
#629 of 694
1995 Dakota 4X4 5.2 V8 by rpw4
Jul 12, 2009 (6:09 pm)
Reply
Hi,
 
I just replaced the front and rear seals along with filter and fluid. The transmission has 75,000 miles on it. It worked fine before changing these items. Now it does not upshift to 3-4 or lockup unless I turn the OD off and then back on. Any suggestions?
#630 of 694
2001 Quadcab 4.7 trans code p0987 by caseyly
Jul 14, 2009 (5:06 am)
Reply
My Dakota has a trouble code from the auto trans P0987 4C Hydraulic Pressure Test Failure. I can't find anyone who can tell me anything about it. Caseyly
#631 of 694
Transfer Shifter not engaging by tbizzle
Jul 14, 2009 (7:24 pm)
Reply
I have a 2000 Dodge Dakota 4.7 liter V8 4x4 and I just pulled into a parking lot and immediately started to hear a clinking of sorts and it sounded like it was coming from the transfer case area. I checked the stick shift for the four wheel and it was loose as if it wasn't engaging at all. I put in the place that it should be and the noise stopped, but the stick didn't "lock" in place. Any ideas what it could be? Is there a clip or something could have come loose?
#632 of 694
Re: Transfer Shifter not engaging [tbizzle] by tbizzle
Jul 15, 2009 (4:16 pm)
Reply

Replying to: tbizzle (Jul 14, 2009 7:24 pm)

I had a chance to get under there today and saw that the shift linkage is detached. It looked like where it should attach is broken or there is a ring missing or both. My Haynes manual tells how to adjust the linkage but doesn't provide any pictures, so I'm not sure if all parts are there or not.
#633 of 694
Driver seat slippage by stevegoodchild
Jul 17, 2009 (11:48 am)
Reply
My newly acquired 2000 Dakota Quad Cab has a minor slippage occurring when seated in the drivers seat. When you brake at a light the seat shifts forward about an inch. Any ideas on repairing this. I understand this happens alot on these vehicles. Thank you
#634 of 694
if someone could help/////////////////////////////////////////// by travis1488
Jul 18, 2009 (11:15 am)
Reply
I just bought a 1992 dodge dakota LE 4x4 ext.cab automatic trans it drives forward fine,but will not go in reverce. You try to put it in reverce and it goes in drive.Even when you put it in nutrule it still will not go backwards its like its lock up for reverce can anybody help????????????????????????????????????????????????????????????????????????????- - ????????????????????????????????????????????????????????????????????????????????- - ????????????????????????????????????????????????????????????????????????????????- - ????????????????????????????????????????????????????????????????????????????????- - ????????????????????????????????????????????????????????????????????????????????- - ??????????????
#635 of 694
Re: Driver seat slippage [stevegoodchild] by kcram HOST
Jul 18, 2009 (6:22 pm)
Reply

Replying to: stevegoodchild (Jul 17, 2009 11:48 am)

Not sure the transmission discussion would be the most helpful look through the Dodge Dakota Interior Issues discussion and see if others may have solved this issue.
 
kcram - Pickups/Wagons Host

Messages Page 64 of 70
1
...
61
62
63
64
65
66
67
...
70
Prev
Next
Last
Go To Msg #
Search This Discussion
To POST a message, please Sign In.

New? Join Now!

Forum Tools

Please sign in.
Email Address:

Password:

Forgot Password?

Search Forums

Enter Keyword(s)

Advanced Search

Browse by Vehicle



View All Vehicles
Advertisement
Ask the Community
See What People Are Asking

Browse by Board

Browse by Topic


View All Topics
Advertisement