Sign In Join 



Chevrolet Blazer Brake Problems

75 messages,  Last post on Sep 07, 2009 at 6:45 AM

You are in the Chevrolet Blazer Forum. Your Hosts are steve_ & tidester

What is this discussion about? GMC, GMC Jimmy, Brakes, SUV


Messages Page 6 of 8
1
2
3
4
5
6
7
8
Prev
Next
Last
Go To Msg #
Search This Discussion

#46 of 75
Rotor replacement by jlflemmons
Oct 16, 2007 (8:03 pm)
Reply
Haven't got the vehicle here to look at right now, but wondering about front rotor replacement on a '99 2wd. Is the rotor pressed onto the hub, or is it easy to get the rotor off the hub?
 
Thanks,
 
Jim
#47 of 75
Re: Rotor replacement [jlflemmons] by jlflemmons
Oct 20, 2007 (5:05 pm)
Reply

Replying to: jlflemmons (Oct 16, 2007 8:03 pm)

Figured it out. Was a very simple design, though not one I had seen before. The bearings and spindle are one unit, and the rotor simply slips on over the lugs like a FWD car.
 
Now, getting it off of an 8 year old car took some 8lb persuasion, but still a simple repair.
#48 of 75
1999 4WD Blazer Brake problems by bernja
Jan 21, 2008 (4:18 am)
Reply
My husband replaced the rear brake pads, rotors, and calipers. We have bled the brakes (all four wheels a couple of time), but brake petal is still spongy. Any ideas on what else to check? Thanks!
#50 of 75
Rear Brake Problem with 2000 Blazer by sands53042
Feb 19, 2008 (4:12 pm)
Reply
I have a 2000 4X4 Blazer with rear brake problems. For some reason, the rear brakes aren't grabbing. There's no air in the lines. I've bled the brakes a few times to try to fix the problem, so I know that's okay. After I bleed them, they will work for a day or two, but then quit working for no reason. There are no leaks that I can find, and there's plenty of brake fluid. Can anyone give me an idea of where to start to try to fix this problem?
#52 of 75
where the heck did the brake fluid go to??? by dan134
Apr 21, 2008 (8:16 pm)
Reply
im doing the brakes on my cousins 99 blazer and when i checked the fluid the resovoir for the rears was empty. so i thought that there was a hole in the line some where. but i cant find any leaks ANYWHERE. it has the abs module sitting on the drivers side inner fender. has anyone had this problem before and know where it mighta went to. it has me all confused.
#53 of 75
Re: where the heck did the brake fluid go to??? [dan134] by Mr_Shiftright HOST
Apr 25, 2008 (10:31 am)
Reply

Replying to: dan134 (Apr 21, 2008 8:16 pm)

Sometimes vacuum from a defective power brake booster can suck it out and burn it in the engine. Otherwise you might have to test the system with a power bleeder. You might also look for brake fluid leaking under the dash, under the carpeting, by the brake pedal.
#54 of 75
Re: where the heck did the brake fluid go to??? [dan134] by jlflemmons
Apr 25, 2008 (3:29 pm)
Reply

Replying to: dan134 (Apr 21, 2008 8:16 pm)

Have you already pulled the calipers and checked for a leak there?
#55 of 75
ABS system on 97 Blazer by booog
May 22, 2008 (11:58 am)
Reply
At times my ABS kicks in when it's not needed, no slipping and low speed. Brought it to a mechanic who quoted $1090 to replace the Wheel Speed Sensor and EBCM. Not sure this car is even worth $1k anymore. I've disconnected the ABS system and it's not happening anymore. Is it all right to drive with the ABS disconnected? Or is there a less expensive solution?

Messages Page 6 of 8
1
2
3
4
5
6
7
8
Prev
Next
Last
Go To Msg #
Search This Discussion
To POST a message, please Sign In.

New? Join Now!

Forum Tools

Please sign in.
Email Address:

Password:

Forgot Password?

Search Forums

Enter Keyword(s)

Advanced Search

Browse by Vehicle



View All Vehicles
Advertisement
Ask the Community
See What People Are Asking

Browse by Board

Browse by Topic


View All Topics

Today's Chats

Advertisement