You are here: Forums SUVs GMC Yukon 2007 Chevrolet Tahoe/GMC Yukon

2007 Chevrolet Tahoe/GMC Yukon

3125 messages,  Last post on Nov 27, 2009 at 6:32 PM

You are in the GMC Yukon Forum. Your Hosts are steve_ & tidester

What is this discussion about? Chevrolet Tahoe, GMC Yukon, SUV

Messages Page 313 of 313 1 ... 307 308 309 310 311 312 313 Prev Next Last

Go To Msg # Search This Discussion

#3120 of 3125 Radio/Nav/AC Bezel Removal by gregpet Oct 28, 2009 (6:36 pm)
I have a 2007 Tahoe with about 40k miles (just out of warranty!) and would like to remove the bezel (plastic woodgrain piece) that surrounds the radio/nav & AC controls. A barely noticable but very annoying crackle has started and it sounds like it's coming from behind the bezel. I'm thinking maybe a screw has become a little lose which is causing the noise. I would like to get in behind and just tighten everything down...   Has anyone had any experience removing this piece? Are there any removal instructions out on the web? It's a pretty tight fit so I don't want to just start prying on it and see if it pops off. Maybe there is a special tool??   Any help would be appreciated...   Thanks,   Greg Replies to this message: seabyrd (Oct 28, 2009 6:53 pm) gfraigun (Oct 29, 2009 11:39 am)
#3121 of 3125 Re: Radio/Nav/AC Bezel Removal [gregpet] by seabyrd Oct 28, 2009 (6:53 pm)
Replying to: gregpet (Oct 28, 2009 6:36 pm) The bezal on my 07 Suburban Z71 just pops off... it takes quite a lot of force but it doesn't have any screws in it.. I used 2 plastic spatulas to slide carefully in behind it and pull it off... It feels like it will break but it didn't. It really takes a lot of pull to pop it off !! Don't know what could be loose but being what it is today... it could be anything. Goodluck !!
#3122 of 3125 Re: Radio/Nav/AC Bezel Removal [gregpet] by gfraigun Oct 29, 2009 (11:39 am)
Replying to: gregpet (Oct 28, 2009 6:36 pm) You can find videos showing hoe to install nav unlocks. These videos show ho to open the radio panel.
#3123 of 3125 Re: DVD/Nav Bypass/Hack [valvestud] by 07lbh Nov 27, 2009 (5:48 am)
Replying to: valvestud (Sep 29, 2006 7:48 pm) Hello,   I hope you can help me. I have a 2007 Tahoe and I am desperately trying to find a 12V ignition switched wire that I can hook a GPS up to. I read a previous post you made way back in 2006. Where you stated "Also, the single orange wire is a 12V ignition switched source the customer can use for various accessories like a radar detector. Switch 1 on the DIP switch must be turned on to enable this feature. I spent several hours trying to find a switched 12V on my Denali, so this is a nice feature."   Where is this orange wire and what DIP switch do I need to move? Replies to this message: rsht (Nov 27, 2009 6:21 am) 73shark (Nov 27, 2009 6:32 pm)
#3124 of 3125 Re: DVD/Nav Bypass/Hack [07lbh] by rsht Nov 27, 2009 (6:21 am)
Replying to: 07lbh (Nov 27, 2009 5:48 am) Would something like the dual fuse holder (see the URL below) work for you? There may be circuit design change from the 2006 to 2007 models... Hope this will work rather than having to change the DIP switch setting.   http://www.jcwhitney.com/TAPA_CIRCUIT_WITH_DUAL_FUSE_HOLDER?ID=12;0;0;0;100001;P- roductName;0;0;0;0;2005174;0;0#
#3125 of 3125 Re: DVD/Nav Bypass/Hack [07lbh] by 73shark Nov 27, 2009 (6:32 pm)
Replying to: 07lbh (Nov 27, 2009 5:48 am) The rear view mirror connector has a switched +12V and ground. Google "Invisicord" which makes cables for radar detectors and shows which pins to use.

Messages Page 313 of 313 1 ... 307 308 309 310 311 312 313 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums SUVs GMC Yukon 2007 Chevrolet Tahoe/GMC Yukon