Edmunds.com | Inside Line | Auto Observer Your Account | Help | Directory
You are here:
![[F]](http://a332.g.akamai.net/f/332/936/12h/www.edmunds.com/media/townhall/webxicons/site.gif){kind=small}
Forums
Pickups Chevrolet Silverado & GMC Sierra Chevy Silverado and GMC Sierra Gasoline Engine Problems
258 messages, Last post on Nov 26, 2009 at 1:55 PM
You are in the Chevrolet Silverado & GMC Sierra Forum. Your Host is kcram
| On the Chevy Silv., 2001 - 6.0l vortec, w/ 298k miles...the oil pressure gauge is bouncing back and forth between 30 and 60 while i drive and it will literally go to zero (0) if i stay in idle/park and the message light will say check oil pressure and the truck will cut off. Think the oil pump is bad; going bad; the lifter/s or valve/s is tapping sorta loud? Thanks in advance for any advice. Kevin | |
|
Replying to: jerryk2 (Jun 29, 2008 12:55 pm) |
|
|
I have a 6.2 Flex fuel 09 403HP. My question is does anyone know how the roller lifters are oiled in my engine? In the old days of hydraulic and solid lifters splash seemed to work in non Hi-Perf. motors. I have read on some forums that roller lifters and roller rockers need lube. It is said,in low rpm range, MODERN ENGINES do not splash as much oil as older motors and the needle bearings of modern motors need oiling at low RPM's (2000 to 3000RPMs) or might have wear and breakage issues. Does any one in this community know of or heard any or some or just a few 6.2 L 403 HP V8's having roller issues? Does anyone know specificly,does the 6.2 have mist,pressure or non needle bearing rollers? I run syn. oil and will be running Oil analysis so I assume I would know if the needle bearing are wearing it would show even though I am running a bypass system that has a 2 micron absolute filtering. Ideas and opinions would be appreciated. |
|
| My 2000 Silverado has a P0300 code. I have done all of the stuff I have read about on the internet. New fuel filter, cleaned injectors, new plugs, checked for vacuum leaks, etc, etc. I finally gave up and took the truck to a mechanic. He found misfire history on cyl 1 & 6. Strangely they have the exact same misfire count. I took the #6 injector and swapped with #2. Drove the truck and went back. The same counts again on the same cylinders. Why 1 and 6? Why the same count? He now wants to check wiring since 1 and 6 fuel injector pins are next to each other on the PCM. There aren't any misfires at idle. Only at highway speed. I'm thinking the PCM is corrupt and should be flashed. Any other thoughts from you guys? Thanks | |
You are here:
Forums
Pickups Chevrolet Silverado & GMC Sierra Chevy Silverado and GMC Sierra Gasoline Engine Problems
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2010 Chevrolet Silverado 1500
2010 GMC Sierra 1500
2004 Chevrolet Silverado 2500
2004 GMC Sierra 2500
2006 Chevrolet Silverado 3500
2006 GMC Sierra 3500
Browse by Board
Browse by Topic
