Edmunds.com | Inside Line | Auto Observer Your Account | Help | Directory
You are here:
![[F]](http://a332.g.akamai.net/f/332/936/12h/www.edmunds.com/media/townhall/webxicons/site.gif){kind=small}
Forums
Pickups Chevrolet Silverado & GMC Sierra Chevy Silverado and GMC Sierra 4x4 Questions
233 messages, Last post on Nov 08, 2009 at 11:21 PM
You are in the Chevrolet Silverado & GMC Sierra Forum. Your Host is kcram
|
Replying to: vinceblas (Jan 04, 2008 9:11 am) kcram - Pickups Host
|
|
|
I have a Chevy 2500 4x4 with push button 4x4 and Auto 4x4. The Truck shifts into 4x4 HI, Lo and Auto 4x4 fine. However 5-10 seconds later the 4x4 service light comes on. Also I cannot shift it out of 4x4 mode - pressing the 2w button has no effect regardless of if I am in Drive, Park or Neutral. However, If I turn off the truck and then turn it back on I can press the 2w button and it will go back into 2w mode just fine. This problem happens every time I try to go into any of the three 4w modes. The repeatability of it sounds like I'm doing something wrong. I should add that the truck has a 6" lift kit and 365/65R16 tires. It also has 74K miles. I also have another problem with hard "clunk" shifting when the transmission is upshifting. It downshifts smooth. This only happens after the truck has run for 15 - 20 minutes. After turning off the truck for 10 minutes or so, like when getting gas, it will shift smooth as silk. Any ideas. Thanks for any help. |
|
|
Replying to: kcram (Jan 04, 2008 6:40 pm) |
|
|
|
|
Replying to: strodsfam (Jan 05, 2008 2:10 pm) The reason for the failure of the encoder motor on my 4wd was due to a bearing freezing on the sector shaft, this shaft connects to the encoder motor. The transfer case was cracked allowing water/salt to corrode the sector shaft bearing resulting in the encoder motor failure. The transfer case crack... I don't think it was a crack from impact. I think it was a bad casting from the factory because of the location of the crack. JB weld in the crack fixed the problem along with a new sector shaft bearing and encoder motor. link for encoder motor for your truck http://stores.channeladvisor.com/Auto-Parts-Direct-To-You/Items/1420002-gmc%20c%- 20series? dealer cost to fix this apx. $1200.00
|
|
|
Replying to: bruce48532 (Jan 07, 2008 6:12 am) |
|
i have a 2003 sierra my prob is my 4hi and 4lo dont engage but my auto 4 does work. when puttin into 4 lo it does gear down but front wheels do not engage could this be the encoder motor on the transfer case. any suggestions would be greatly apreciated. I can hear it is tryin to engage when i push either the 4 hi or 4lo buttons but like i said the front wheels dont engage
|
|
|
Replying to: bruce48532 (Jan 07, 2008 6:12 am)
|
|
|
My 4 wheel drive went out this past week without any warning. I backed up to turn around and when I put it back into drive it made a grinding noise and the front wheels quit pulling. I tried several times and it would never engage again just the grinding, like gears not fully meshed. When I push the button it feels and acts like it engages 4hi and/or 4lo. I've read most of the posts on here and most just say theirs just quit working and it's the actuator motor. Is it possible that it is only partially engaging? Could it be the autolocking hubs? I haven't had time to check if the axles or drive line are turning, dark to work dark when I get home. I just need some advice for when I start on it this weekend. My truck has 172,000 on it and I've never had any other problems except fuel pump (twice). Any help in the right direction would be a greatly appreciated. Thanks osweeks
|
|
|
|
|
Replying to: strodsfam (Jan 08, 2008 4:07 pm) |
|
|
|
|
Replying to: ballz78 (Jan 07, 2008 5:48 pm) Common 4wd problems Speed sensor bad ( this is a recall on some trucks check with your dealer) - hard shifting, cluncking noise when shifting Bad dash selector switch (bad solider or connector) - not lights lite on the selector switch. Font axle actuator - No front wheel drive Transfer case encoder motor - will not shift out of or go into 4hi or 4 low my guess speed sensor or encoder motor |
|
You are here:
Forums
Pickups Chevrolet Silverado & GMC Sierra Chevy Silverado and GMC Sierra 4x4 Questions
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2010 Chevrolet Silverado 1500
2004 Chevrolet Silverado 2500
2006 Chevrolet Silverado 3500
2010 GMC Sierra 1500
2004 GMC Sierra 2500
2006 GMC Sierra 3500
Browse by Board
Browse by Topic
Today's Chats
