You are here:
Forums
Pickups
Chevrolet Silverado & GMC Sierra
Chevy Silverado and GMC Sierra 4x4 Questions

239 messages, Last post on Dec 01, 2009 at 1:47 PM
You are in the Chevrolet Silverado & GMC Sierra Forum. Your Host is kcram
|
|
|---|---|
I Changed the Actuator but the 4X4 Wont Luck In. Someone told me that it has another switch but I cant find it Please Help.
|
|
|
|
|
Replying to: jasper12 (Dec 04, 2007 4:51 pm) Also sector shaft bearing in the transfer case replaced again by dealer $ 610. The sector shaft connects the transfer case motor. Personally my opinion, with the thousands of dollars I've spent on 4wd repair and the additional cost to the truck purchase for auto 4wd. GM should go back to manual shift, they cannot seem to get it right. |
|
|
|
|
Replying to: conclutcha (Dec 04, 2007 8:10 pm) it could be the actuator motor on the transfer case that is your problem or it could be my most recent problem the sector shaft bearing in the transfer case. |
|
|
|
| Thank you For Your Info I Will Look At Some To Look For This Parts | |
|
Hello everyone, I am new to the board, and have looked for a similar problem as mine, but can not find one. I have a 2005 Z 71, with push button, 4WD, and the "auto" mode. I drive in 2wd, 30 minutes, 75mph, each way to work. Tranny works fine (with chevy's normal rough shifting) The other day I noticed the red light next to "neutral" was on instead of the amber light next to 2 Hi. The truck was running fine, and when I pushed the 2wd button, amber flashed for a few seconds, and went off. I pulled over, shut off the motor, restarted, and it apperantly reset. I thought life was good. Now I have noticed the red light on three more times, and it doesn't reset by simply restarting. It is very random when it is on, or off. Any simmilar stories or advice? |
|
| I have a 4wd 1999 Gmc sierra 1500 and for some reason there are no push buttons in the dash. Does anyone know where i can buy any? | |
| good thing i wasnt waiting on some help from you people never mind,i will figure it out on my own | |
| My 2002 Z71 4x4 service light is on ! My 2002 Z71 4x4 service light is on !My 2002 Z71 4x4 service light is on !My 4x4 buttons do not work, and the 4x4 service light is on. I press the 4x4 buttons on the dash, and the 4x4 does not engage. Also my ABS light is on. It happened when the towed my vehicle. I am trying to work it out with the towing company. | |
I recently purchased an 04 GMC Sierra 2500 that was rolled over, after replacing the roof and other body damage (no damage to the front, rear or under carriage) I tried to engage the 4 wheel drive, the blinking lights tells me that it is engaged in 4 wheel drive. I hear it engaging in the transfer case, but the front axles do not engage. I purchased an actuator and installed it. It did not make any difference. On the highway it runs perfectly and quietly. Can you offer any suggestions on this matter?
|
|
|
|
|
Replying to: boso56 (Dec 15, 2007 9:12 am) There are (2) actuators! The blinking light should go from blinking to solid, I assume that is what is happening? Did you reset the computer defalt after installing the new acturator? If not try that! (3) quick on and off turns of the ignition switch, then start it.
|
|
You are here:
Forums
Pickups
Chevrolet Silverado & GMC Sierra
Chevy Silverado and GMC Sierra 4x4 Questions
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2010 Chevrolet Silverado 1500
2004 Chevrolet Silverado 2500
2006 Chevrolet Silverado 3500
2010 GMC Sierra 1500
2004 GMC Sierra 2500
2006 GMC Sierra 3500



Browse by Board
Browse by Topic