You are here:
Forums
Pickups
Chevrolet Silverado & GMC Sierra
Chevy Silverado and GMC Sierra 4x4 Questions

236 messages, Last post on Nov 17, 2009 at 5:35 AM
You are in the Chevrolet Silverado & GMC Sierra Forum. Your Host is kcram
|
Replying to: bhanley55 (Oct 07, 2009 6:22 pm) |
|
|
|
|
Replying to: bhanley55 (Oct 07, 2009 6:22 pm) |
|
So I have a 97 gmc sierra Z71 with an auto trans it does not have push button it has the 4wd shifter on the floor the transfer case engages and the front driveline is rotating when in 4wd I had replaced the actuator on the front axle figuring it was a simple fix and it is still
|
|
|
|
|
Replying to: brigs3916 (Nov 12, 2009 8:01 pm) If you don't have push button on the dash what sends the signal to the front actuator? Possible it is something electrical to do with the fron actuator? May still be a simple fix? $20 for a Haynes Repair manual might be a good investment? OR? If the front drive shaft is rotating after manually locking in the transfer case and you have replaced the front actuator, then it sounds like maybe the transfercase is burned out? My guess there is enough friction on the clutch plates in the transfer case to rotate the front drive shaft but not under load? How many miles on the truck, I rebuilt my transfer case at 110k miles, it was not completely gone but did not work as it should. The clutch plates total apx 12 ? only 2-3 were worn out. Parts cost to rebuild the transfer case apx $150 and apx 6 hrs time. Good Luck! |
|
|
|
|
Replying to: bhanley55 (Oct 07, 2009 6:22 pm) |
|
You are here:
Forums
Pickups
Chevrolet Silverado & GMC Sierra
Chevy Silverado and GMC Sierra 4x4 Questions
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2010 Chevrolet Silverado 1500
2004 Chevrolet Silverado 2500
2006 Chevrolet Silverado 3500
2010 GMC Sierra 1500
2004 GMC Sierra 2500
2006 GMC Sierra 3500



Browse by Board
Browse by Topic