Sign In Join 



Chevy S10 - GMC S15 and Sonoma Stalling/Dying issues

168 messages,  Last post on Nov 02, 2009 at 11:36 AM

You are in the Chevrolet S-10 & GMC S15 Sonoma Forum. Your Host is kcram

What is this discussion about? Chevrolet S-10, GMC Sonoma, GMC S-15, Truck


Messages Page 10 of 18
1
...
7
8
9
10
11
12
13
...
18
Prev
Next
Last
Go To Msg #
Search This Discussion

#87 of 168
Re: cutting out [reddawg1] by keltecbob
Nov 16, 2007 (2:52 pm)
Reply

Replying to: reddawg1 (Nov 15, 2007 1:32 pm)

My son has a 91 s15 that stumbles on acceleration. I have replaced the fuel regulator, fuel filter, replaced plugs, check wires for continuity, replaced o2 sensor. This vehicle idles fine until it reaches running temp. then it stumbles severely on accerleration and then throws rich fuel mixture on the o2 sensor. How much fuel should one see coming out of the injectors into the throttle body while it is idling. This one seems to be alot. I can see it covering the walls and plate pretty well just when idling. I tried to test the tps and the ignition coil and the ignition pickup inside the dist. but not sure if I am doing it right. Any help would be appreciated.
 
Bob
#88 of 168
1988 Chevy S-10 running problems by michelle1971
Nov 22, 2007 (6:10 pm)
Reply
1988 Chevy S-10 2.6 V-6 4 wheel drive.When I
drive the truck for 30 minutes I have to keep my
foot on the gas a little, because If I don't the
truck dies, and when I start it up it acts like the
battery doesn't have the volts, but it only does
this when the engine is normal temperature.
Please help me out on this!
#89 of 168
dying if I don't keep foot on gas after it warms up by michelle1971
Nov 23, 2007 (6:51 pm)
Reply
When the truck warms up to normal temp,when I stop at traffic lights or stop signs,
if I don't keep my foot on the gas stopped,the truck will die and when I try to
start it up the starter tries to drag only when it dies.Please help me out with
a solution?
#90 of 168
Re: S10 1995 2.2 JUST DIE / pls help [s100614] by michaelm5
Dec 02, 2007 (2:43 pm)
Reply

Replying to: s100614 (Mar 15, 2006 4:44 am)

try the ignition module, it goes out,everything goes out except starter. hope this helps
#91 of 168
Re: dying if I don't keep foot on gas after it warms up [michelle1971] by michaelm5
Dec 02, 2007 (2:45 pm)
Reply

Replying to: michelle1971 (Nov 23, 2007 6:51 pm)

try replacing the tps sensor or it may be the injectors
#92 of 168
stalling/dying by airbysilk
Dec 14, 2007 (12:37 am)
Reply
i have a 93 sonoma 2.8 v6 have been having simular problem. have had trouble starting it , will fially fire then after you drive it just dies. put in new fuel pump and today ignition switch. but when i was driving i would turn corner and it just dies, tow bills are getting out of control
please help if you all have figured it out yet
#93 of 168
Re: stalling/dying [airbysilk] by keltecbob
Dec 14, 2007 (9:36 am)
Reply

Replying to: airbysilk (Dec 14, 2007 12:37 am)

I haven't figured my son's truck out yet, but I will let you know when I do.
#94 of 168
S10 unable to accelerate by mptimko
Mar 06, 2008 (5:04 am)
Reply
Hello to all, I come in search of a possible solution. I have a 2000 s10 4wd 4.3 V6 vin W with CPFI (central port fuel inj). Well I have a mind stumper. A few weeks ago, my fuel pump died on me for the 2nd time in 2.5 yrs. So, after much cursing and swearing, I bit the bullet and replaced the pump and harness, flushed the tank, filter etc. It ran ok for a day or two but then it started acting up. What it does is when you start it and go it's great for about 15 minutes and then all of a sudden you can't do anything more than just tap the gas. If you do, say going up a hill or even on flat, it just bogs down and if you geive it even more than half throttle, it backfires up thru the intake, not loudly, but enough. Kinda sounds like when you pull the choke out on your lawnmower and it starts flooding out. At first, you could pull over and shut it off, wait a min and then do it all over again, but now it's gotten progressively worse. I put a full tune up on it when I did the pump, and just yesterday it popped the code for a left bank o2 sensor so I changed that and looked for any vacum leaks but to no avail.. After looking at what else it can be, I have gotten everything from egr valve, throttle pos sensor, maf sensor, clogged cat conv. I am at my wits end cause it ran great until the problem with the pump and I can't go to the garage cause they will kill me on diagnostic charges. Anyone else had this problem????? Thanks for your input
#95 of 168
stalling by red91
Mar 25, 2008 (1:33 pm)
Reply
hi ive got a 91, 2.8 tbi, 2wd, and am having some trouble with it. It will start up and run for a few seconds and then it will run really bad. When taking off it will start to die out in each gear up untill 4th thenit dont as bad. Have put new plugs,wires, cap,roter,coil,fuel fiter,air filter,iac valve,map sensor,egr valve,cat,muffler,02 sensor,cleaned inj,have checked the timing alot and found no vacume leaks,it dont give any code or light,took to shop they said map sensor, and now am looking at a fuel pump or tps or a 350 can yall help , kinda on a budget after th parts

Messages Page 10 of 18
1
...
7
8
9
10
11
12
13
...
18
Prev
Next
Last
Go To Msg #
Search This Discussion
To POST a message, please Sign In.

New? Join Now!

Forum Tools

Please sign in.
Email Address:

Password:

Forgot Password?

Search Forums

Enter Keyword(s)

Advanced Search

Browse by Vehicle



View All Vehicles
Advertisement
Ask the Community
See What People Are Asking

Browse by Board

Browse by Topic


View All Topics
Advertisement