Edmunds.com | Inside Line | Auto Observer Your Account | Help | Directory
You are here:
![[F]](http://a332.g.akamai.net/f/332/936/12h/www.edmunds.com/media/townhall/webxicons/site.gif){kind=small}
Forums
Pickups Chevrolet S-10 & GMC S15 Sonoma Chevy S10 - GMC S15 and Sonoma Stalling/Dying issues
168 messages, Last post on Nov 02, 2009 at 11:36 AM
You are in the Chevrolet S-10 & GMC S15 Sonoma Forum. Your Host is kcram
|
Replying to: mthompson1 (Sep 13, 2008 6:42 am)
|
|
|
Replying to: hayman1 (Dec 15, 2008 4:18 pm) |
|
Had my truck just stall while driving on the road. First thing I though of was maybe a fuel problem, changed the filter and still no luck. Did not think of it at first but realized the fuel pump was not kicking on, also found the battery was drained down. Took the alternator and had it checked and found it was charging at 17 V. Also found the ECM fuse was blown. Changed the fuse and the alternator and the truck started right up, ran for about 3 min and shut right off again. The ECM fuse keeps blowing. Replaced the Fuel pump relay and still no luck. When you turn the key on it instantly blows the ECM fuse. Take the fuel pump relay apart and the fuse does not blow, but naturally the truck won't start. Also just for the sake of spending money to help the economy, I replaced the ECM. Help!!!!!!!! Doc
|
|
|
Replying to: doc15 (Jan 03, 2009 6:26 am)
|
|
| I have also done everything I could think of but still the truck will idle fine but won't move when driving. Fuel pump checked ok, new fuel filter, new air filter, spark plugs, spark wires, distributor cap and rotor. Truck still wants to buck and cut out when cruising going uphill and putting it under a load. Has anyone had any luck with cleaning up the injector contacts under the manifold cover or by replacing the PCM? | |
|
Replying to: gonogo (Jan 03, 2009 7:47 am)  Doc
|
|
|
Replying to: doc15 (Jan 07, 2009 7:10 pm) If I was to do mine I would loosen all the bolts on the passenger side of the bed, leave the nuts on a few threads. Don't forget the wiring, ground, tail lights, fill hose etc.. Remove all the bolts on the driver side, jack up the driver side until you have enough clearance. You must trig the bed really good so it will not fall on you. Well dropping the tank is not too bad if empty, if lots of fuel you need a jack. FWIW the pumps don't usually blow the fuse, a short in the wiring would.
|
|
|
Replying to: gonogo (Jan 08, 2009 8:27 am)  
|
|
|
Replying to: doc15 (Jan 10, 2009 8:47 pm) |
|
|
Have an overheating problem with my 93 Sonoma 4.3 EFI I can't seem to put enough water or coolant in the radiator. I fill it and can stand there and watch the level go down. The radiator just never seems to fill. The other thing is I turned on the heater and it started blowing hot air but then it turned cool. Don't know if these are connected or not? Any suggestions? Thanks, Doc |
|
You are here:
Forums
Pickups Chevrolet S-10 & GMC S15 Sonoma Chevy S10 - GMC S15 and Sonoma Stalling/Dying issues
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2004 Chevrolet S-10
2004 GMC Sonoma
1990 GMC S-15
Browse by Board
Browse by Topic
Today's Chats
