Edmunds.com | Inside Line | Auto Observer Your Account | Help | Directory
You are here:
![[F]](http://a332.g.akamai.net/f/332/936/12h/www.edmunds.com/media/townhall/webxicons/site.gif){kind=small}
Forums
Pickups Chevrolet Silverado & GMC Sierra Chevy Silverado and GMC Sierra Noise and Vibration
172 messages, Last post on Oct 28, 2009 at 1:49 PM
You are in the Chevrolet Silverado & GMC Sierra Forum. Your Host is kcram
| Hey, After looking at westins website, I found that there is a one eight inch minimum clearance on the front body pocket mounts for the steps bracket, sure enough the installer did not follow this in the instructions for installing the tubes, I crawled under the truck the other day and loosend the steps and adjusted to specs, Then torqued to 74 foot pounds, and Voila no more creeks or noise.........Why did i pay someone to install these..........Damn | |
I have a 05 silverado 4X4 5.3 it has a vibration at 45mph-55mph after it shifts in over drive,if i give gas it stops vibrating if i let off the gas it stops vibrating. This happens around 1400 rpms
|
|
| I have an '07 Classic Ext. Cab 2WD 6cyl with 6500 miles. I am taking it in for warranty work today. I have a vibration in the gas pedal that begins at 35mph. There is also a slight vibraton in the steering wheel at the same time. Just wanted to know if anyone else has had a similar problem. | |
|
Replying to: sjsracin (Feb 18, 2008 7:19 am)
|
|
new to the board. o4 silverado 4.8 extended cab. getting a vibration at 45 mph. dealer has checked and rechecked everything from tire balance to replacing the driveshaft. final determination was there isn't a cure except to run with 200-300 lbs of weight in the bed. any thoughts or suggestions?
|
|
|
Replying to: alc8 (Mar 10, 2008 4:18 pm) Use this link to find a hunter near you. Hunter balancer |
|
|
Replying to: alc8 (Mar 10, 2008 4:18 pm) |
|
|
Replying to: chadmcabee (Jan 09, 2008 11:24 am) Getting Chevrolet to honor the new vehicle warranty that I paid for in the price of the truck is like pulling teeth. |
|
|
Hey all I have a problem that I cannot get fixed. I have had the vehicle to the dealer 3 times and they cannot find the problem. Here are the symptoms. When I apply the brakes, the truck starts bouncing in the front end. I have replaced the rotors and brake pads and the ball joints are supposedly good. Had them checked out the last time in, and I was told they are ok. I have bought new upper and lower to replace the old ones, but was told it would be a waste of money. So I guess my question is, should I go ahead and have them replaced anyways, and also have the steering link replaced along with the front end bushings?? Anyone ever come across this problem??? The truck has 190K miles on it and the ball joints are the originals, but I do grease them, along with the rest of the lube points, with every oil change.
|
|
|
Replying to: kyhiker65 (Mar 18, 2008 2:40 pm)
|
|
You are here:
Forums
Pickups Chevrolet Silverado & GMC Sierra Chevy Silverado and GMC Sierra Noise and Vibration
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2010 Chevrolet Silverado 1500
2004 Chevrolet Silverado 2500
2006 Chevrolet Silverado 3500
2010 GMC Sierra 1500
2004 GMC Sierra 2500
2006 GMC Sierra 3500
Browse by Board
Browse by Topic
Today's Chats
