You are here:
Forums
Pickups
Chevrolet S-10 & GMC S15 Sonoma
Chevy S10 - GMC S15 and Sonoma Engine and Underhood Problems

364 messages, Last post on Nov 27, 2009 at 12:19 PM
You are in the Chevrolet S-10 & GMC S15 Sonoma Forum. Your Host is kcram
|
Hi Guys...I have a 2000 GMC sonoma 4cyl.auto flex fuel truck and i keep getting 2 codes Po179 and one for transmission slippage but after reading it all points to the flex fuel sensor located on the chassis under the ac unit on the passenger side ......my question is can i change some stuff to get this back to just a regular gas vehicle and what would it take to do this ..........same chocolate truck on learnmore page regards plexico48
|
|
|
Replying to: plexico48 (Oct 05, 2009 6:17 am) |
|
| Can a bad MAF sensor give me the P0300 Code? The Service engine light comes on and stays on for a few days then goes off for a few days. The truck memory shows the misfire code. When light is on I get a MAF code as well. Where is this part located at on the truck? Thanks for any input as I am wanting to sell this truck but want it fixed first | |
|
|
|
|
| I have a 95 4.3 vortec vin code Z and when I accelerate my motor bogs down to the point it almost shuts off. My fuel gauge and battery gauge go haywire unless i barely touch the gas then it goes fine. I cannot find a posting that specifies this particular motor....any ideas? I have replaced the fuel pressure regulator because an old guy at the parts store recommended that may be the problem. | |
|
Replying to: hoodlatch (Jul 20, 2006 6:18 am) |
|
You are here:
Forums
Pickups
Chevrolet S-10 & GMC S15 Sonoma
Chevy S10 - GMC S15 and Sonoma Engine and Underhood Problems
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
1990 GMC S-15
2004 GMC Sonoma
2004 Chevrolet S-10



Browse by Board
Browse by Topic
Today's Chats