Sign In Join 



Chevy Silverado and GMC Sierra Transmission Problems

506 messages,  Last post on Dec 01, 2009 at 1:57 PM

You are in the Chevrolet Silverado & GMC Sierra Forum. Your Host is kcram

What is this discussion about? Chevrolet Silverado 1500, Chevrolet Silverado 2500, Chevrolet Silverado 3500, GMC Sierra 1500, GMC Sierra 2500, GMC Sierra 3500, Transmission, Truck


Messages Page 39 of 52
1
...
36
37
38
39
40
41
42
...
52
Prev
Next
Last
Go To Msg #
Search This Discussion

#372 of 506
Re: Transmission shifting problems 2003 Z-71 [Pard] by bigblock2
Dec 20, 2008 (2:14 pm)
Reply

Replying to: Pard (Dec 16, 2008 5:58 am)

I have the same trouble with my 2005, Z71, with babied 20,000 miles.... seems to start in third if you let it. If i shut if off for a few minutes and re start the truck it will work fine. I'm thinking one of the servos is sticking ,but like you mentioned the problem is intermittent...
#373 of 506
Removing transmission pan on 04 Sub by jamonett
Dec 20, 2008 (8:19 pm)
Reply
Hello everyone,
   I am having a very difficult time removing the transmission pan on my 04 Suburban. The bracket that holds the shift cable is blocking me from dropping the pan down. I have tried bending it out of the way, but that doesn't work as it is too stiff to bend it very far. And I don't want to break it off of the transmission case. It looks like I need to drop/remove the exhaust Y and then I can "fold" the pan down at a 90 degree angle and slip it out from behind the bracket.
 
Any suggestions?
 
Thank you in advance for any help.
 
John
#374 of 506
Re: Removing transmission pan on 04 Sub [jamonett] by obyone
Dec 20, 2008 (10:15 pm)
Reply

Replying to: jamonett (Dec 20, 2008 8:19 pm)

Do you have the 5.3 or 6.0?
#375 of 506
4L80-E Auto Trans Wire Harness Fluid Leak by JParke
Dec 21, 2008 (2:43 am)
Reply
Trans fluid is leaking through the wire harness plug. What is the cause. Is replacing the harness the only remedy? Can the fluid cause a short circuit at the plug. What seals the plug on the inside of the case? How difficult is it to replace the harness?
 
Jim
#376 of 506
DRAGRACER30 by DRAGRACER30
Dec 25, 2008 (7:12 pm)
Reply
I HAVE A 01 CHEVY 2500 WITH AN ALLISON 1000 TRANSMISSION. THE TRANSMISSION IS STARTING OFF IN 1ST GEAR AND IMMEDIATELY SLAMS INTO 3RD GEAR. IT IS THROWING A P1711 CODE. THE SILINOID HAS BEEN CHECKED AND IT IS NOT THAT. WHAT ELSE COULD MAKE IT THROW SLAM INTO 3RD GEAR AND THROW THAT CODE? PLEASE HELP!!!!!!!!!!!!
#377 of 506
2004 silverado 4th gear problems by geez150
Dec 26, 2008 (8:59 am)
Reply
My 2004 chevy silverado 5.3 4x4 is having tranny trouble. After the tranny shifts into 4th gear and i'm doing about 40-55mph and in the rpm range of 1500-1800 it starts bucking bad. If i either speed up to say 60 it goes away or if i slow down it goes away. The STEALER has no clue! Any help would be great!
#378 of 506
tranny clunking by freewheelin1
Jan 03, 2009 (2:28 pm)
Reply
When I accelerate from a red light sometimes i hear a clunking from the tranny going into second gear and less so into third. I thought i read somewhere that the gear changing in Sierra's are noisy.... is this the case or should i consult someone that the tranny might be going.... I JUST bought it ...an 05 GMC Sierra 4x4 34,796 miles. It seems to occur more often when i accelerate a bit harder.
#379 of 506
2001 2500 4L80E shifting problem by bluedroptop
Jan 03, 2009 (8:04 pm)
Reply
When the trans. temp. is between 100 and 150 degrees, the trans. shifts hard from 1st to 2nd. This isn't a constant problem, just occasional. Otherwise the trans. works fine. Any suggestion as to what is causing this problem, or remedies. Any info will be helpful.
 
Thanks, bluedroptop
#380 of 506
update on 2004 by geez150
Jan 04, 2009 (5:02 pm)
Reply
update on my 2004 chevy silverado 5.3 4x4 with 31,000 on it, picking it up for the stealer tomorrow, they replaced the torque converter on it, so hopefully the problem will be gone
#381 of 506
1999 gmc sierra 2500 no reverse when trans is hot by GMCATW
Jan 10, 2009 (6:48 pm)
Reply
1999 GMC Sierra 2500 4x4 Hi.. Does any body have any idea about my transmission. I do snow plowing and after couple of hours of driving back and forth, my truck wont go in reverse for some reason so i have to park the truck for 15 minutes to cool down it works fine after that, any ideas guys. Thanks

Messages Page 39 of 52
1
...
36
37
38
39
40
41
42
...
52
Prev
Next
Last
Go To Msg #
Search This Discussion
To POST a message, please Sign In.

New? Join Now!

Forum Tools

Please sign in.
Email Address:

Password:

Forgot Password?

Search Forums

Enter Keyword(s)

Advanced Search

Browse by Vehicle



View All Vehicles
Advertisement
Ask the Community
See What People Are Asking

Browse by Board

Browse by Topic


View All Topics

Today's Chats

Advertisement