Diesel Questions/Problems in General (non specific makes)

146 messages, Last post on Nov 04, 2009 at 5:28 PM

You are in the Maintenance & Repair Forum. Your Host is mr_shiftright

What is this discussion about? Engine, Exhaust, Diesel, Hatchback, Truck, Sedan, Wagon

This topic is for diesel car and truck owners who have not been able to find satisfactory information in the forums dealing with their particular vehicles (please use SEARCH on left of page before you post here).

Outline

Messages Page 16 of 16: 1; ...; 10; 11; 12; 13; 14; 15; 16; Prev; Next; Last

#142 of 146 Re: 7.3 no start [fphilli1] by Mr_Shiftright HOST Mar 04, 2009 (2:25 pm)
Replying to: fphilli1 (Mar 04, 2009 1:27 pm) One wonders why a 20 amp fuse would blow, so this may not be the end of the story but I hope it is for you.
#143 of 146 Primer pump by szewski May 17, 2009 (3:21 pm)
Where is the primer pump located on a 2003 chevy duramax diesel ?? Replies to this message: Mr_Shiftright (May 17, 2009 7:10 pm)
#144 of 146 Re: Primer pump [szewski] by Mr_Shiftright HOST May 17, 2009 (7:10 pm)
Replying to: szewski (May 17, 2009 3:21 pm) 1. Looks like it's on top of the fuel filter 2. Open the vent valve (small screw) by turning the screw counterclockwise several full turns. 3. Operate the priming pump (pump it up and down with your palm) "> until a small amount of fuel seeps from the vent valve. allow the pump to return upwards between pumps. When fuel is present, the filter is full of fuel and the system should be primed. 4. Close the vent valve. 5. Clean any fuel which accumulated on the fuel filter. 6. Start the engine and allow it to idle for a few minutes. 7. Check the filter for leaks.
#145 of 146 i dont understand by helpmeporfavor Nov 04, 2009 (1:55 pm)
OK i have knowlage of diesel engines but i am stumped on this one i got a 2.0 diesel and where the injectors go into the engine the inlets on two cylnders melted and fell into the cylynders and ruined two of the pistons i cant understand this how could it happen any ideas please i am going crazy Replies to this message: Mr_Shiftright (Nov 04, 2009 5:28 pm)
#146 of 146 Re: i dont understand [helpmeporfavor] by Mr_Shiftright HOST Nov 04, 2009 (5:28 pm)
Replying to: helpmeporfavor (Nov 04, 2009 1:55 pm) Sounds like detonation damage perhaps, or a massive overheat? Were the glow plugs damaged as well? Did the pistons chunk out (pieces broken off the piston tops).