Sign In Join 



Ford F-Series Computer Problems

92 messages,  Last post on Dec 05, 2009 at 9:30 AM

You are in the Ford F-Series Forum. Your Host is kcram

What is this discussion about? Ford F-250 Super Duty, Ford F-150, Ford F-350 Super Duty, Electrical, Truck


Messages Page 7 of 10
1
...
4
5
6
7
8
9
10
Prev
Next
Last
Go To Msg #
Search This Discussion

#55 of 92
2006 Ford F250 Super Duty Diesel Air Bag Light by Mountainguy
Jan 01, 2009 (5:46 pm)
Reply
I have a 2006 Ford F250 Super Duty Diesel
with an air bag light on. Used a scanner
and is flashing 032 code. My Chilton manual
does not have any information for air bag codes
and says to take to dealor. Any info on this type of
problem or info on this trouble code would be appreciated.
#56 of 92
2002 F250 Super Duty no start by greenhornit
Jan 06, 2009 (6:26 pm)
Reply
turn the key on and the ICM relay clicks cont.,no power to fuel pump or glow plugs. PCM must be out right?
#57 of 92
Re: 6.8L V10 computer problems??? [cable_guyxxx] by tibodo6
Jan 19, 2009 (10:02 am)
Reply

Replying to: cable_guyxxx (Jan 31, 2008 10:10 am)

I have a 2000 f 250 v10 and it has the same problem but the engine light will flicker and not run right. if the light stays on theres no power i've narrowed the problem to the computer plug in my truck condensation get's in it and causes it to short out so i take it out and dry the computer side i still have not came up with a solution to stop it from condisatiing from but it stops it from happening for a good while
#58 of 92
Re: 6.8L V10 computer problems??? [tibodo6] by trobld12345
Jan 20, 2009 (12:23 pm)
Reply

Replying to: tibodo6 (Jan 19, 2009 10:02 am)

i got the same problem with my truck but when mine first did it it sheered the gears in my rear axle nd cracked my tranny replaced them and it has a hard shift and no power with the pcm hooked up disconnect it got some power back but then my torque converter went out had a shop run a diagnostic they told me the pcm was bad because it didnt send a signal 6 months later im just about fed up i think it could be the condensation when i took it out it looked a little wet but havent hooked it back up due to the torque converter being out any ideas on how to keep it dry
#59 of 92
Re: 2001 F350 7.3 Throttle unresponsive engine light on [johnny_bravo38] by robing1
Jan 26, 2009 (1:09 pm)
Reply

Replying to: johnny_bravo38 (Jun 26, 2007 9:01 am)

check your peddle assy. or throttle position sensor(fuel peddle) it has 3 bolts that hold it in place and a plug assy that needs to be disconnected. if you replace this assy it will fix your problem. what leads me to believe that is i had the same problem with one of my trucks and i could run it using cruise but the peddle wouldnt work. it should fix your problem.
#60 of 92
Ford 2002 F-150 by snowman61963
Feb 06, 2009 (4:36 pm)
Reply
Went to start up truck at work all gauges showed fine except for speedometer and tach did not go through cycle. Had power to rest of dash lights but could not start truck, any ideas??
#61 of 92
check engine light on by aurrelio
Feb 22, 2009 (5:53 pm)
Reply
Hi guys... there is a possibility that my check engine light turn's on because my gas cap is no good?
#62 of 92
by aurrelio
Feb 22, 2009 (5:57 pm)
Reply
first time using this....anybody there?
#63 of 92
Re: [aurrelio] by emtdawn
Feb 22, 2009 (6:10 pm)
Reply

Replying to: aurrelio (Feb 22, 2009 5:57 pm)

This is not constantly monitored by any one person. If a question regarding our particular vehicle is asked, we get an email if we chose to "want to respond" to questions asked about our particular make, model, etc. I was checking in regarding a question as to whether or not your "check engine light" would come on if your gas cap is bad.. in an F-150 model. That's when I saw your post. This isn't like a live "blog" where someone is sitting here waiting for someone else to write something or ask a question. If you have a question, type it in and submit it. Someone will come back and respond to it if they can answer you or if they can tell you where you can find the answer, particularly if they know! Good luck.
#64 of 92
wiper issue on 02 f-350 cuts out motor and throws code po-344 (cam sensor) by doc46
Mar 05, 2009 (2:49 pm)
Reply
vehicle only cuts out or misses and ck engine lt only comes on when wipers are on ( even when dry) in intermittent only, i noticed others w/ same problem any fixes?

Messages Page 7 of 10
1
...
4
5
6
7
8
9
10
Prev
Next
Last
Go To Msg #
Search This Discussion
To POST a message, please Sign In.

New? Join Now!

Forum Tools

Please sign in.
Email Address:

Password:

Forgot Password?

Search Forums

Enter Keyword(s)

Advanced Search

Browse by Vehicle



View All Vehicles
Advertisement
Ask the Community
See What People Are Asking

Browse by Board

Browse by Topic


View All Topics

Today's Chats

Advertisement