- #36 of 231
-
Re: Broken bolt on water pump [Mr_Shiftright]
by deacon2
-
Jan 12, 2007 (6:30 am)
-
|
|
Replying to: Mr_Shiftright (Jan 10, 2007 9:28 am)
I went to Lowes and got a blackgold drill bit as well as a diamond grit drill bit. Figured I would give the blackgold a try since they say they are "stronger and sharper". They were the only place I could find the diamond grit drill bit. Here's to hoping.....
|
- #37 of 231
-
Re: Broken bolt on water pump [deacon2]
by Mr_Shiftright HOST
-
Jan 12, 2007 (8:41 am)
-
|
|
Replying to: deacon2 (Jan 12, 2007 6:30 am)
Do you have a stout metal punch to punch out a starter hole before you drill?
|
- #38 of 231
-
Re: 93 Ford Bronco w/ throttle sensor problems [daveshir]
by oldblue3
-
Mar 27, 2007 (5:46 pm)
-
|
|
Replying to: daveshir (Jul 08, 2006 9:17 am)
I have had a few dozen of these broncos the motor is probably the problem 4 the wipers your wiring problem is probably at the front of the bronco by the battery the wires always get pinched right there there is also a wire there that will effect the running condition of the truck and radio shack sells a nice wire cleaner 4 about 6.00 bucks a can
|
- #39 of 231
-
Re: Broken bolt on water pump [Mr_Shiftright]
by oldblue3
-
Mar 27, 2007 (5:48 pm)
-
|
|
Replying to: Mr_Shiftright (Jan 12, 2007 8:41 am)
yes spring loaded impact center punch available at any local car parts chain
|
- #40 of 231
-
Re: Front End 93 eddie bauer 5.8 [devinque]
by oldblue3
-
Mar 27, 2007 (5:52 pm)
-
|
|
Replying to: devinque (Sep 01, 2006 8:19 pm)
check your lower ball joints
|
- #41 of 231
-
Re: 95 Bronco Transmission Problem [rpierce3]
by oldblue3
-
Mar 27, 2007 (6:09 pm)
-
|
|
Replying to: rpierce3 (Sep 25, 2006 4:18 pm)
about 3.00 to4.00 hundred you can save some if you choose to pull it yourself yes a 4wd truck trans will work providing its close to your year and make sure to put in an extra trans cooler with an electric fan it will cost a little extra but well worth it these trannys are known for overheating and the cooler and fan will increase the life of the new one a lot hope i helped you and good luck
|
- #42 of 231
-
95 ABS light
by falcon8
-
Apr 03, 2007 (5:52 pm)
-
|
|
ABS light staying on.Checked relay and fuses.Not sure what resistance should be for sensors.Could I use a hand held code scanner to get codes, same one for ecm?
|
- #43 of 231
-
85 Bronco Feedback Carburetor
by art20
-
May 25, 2007 (4:53 pm)
-
|
|
I´m repairing YFA Carter Carburetor. There is a Sticker attached close to radiator that indicates that antidiesel screw must not be used to adjust idle speed and indicates to see Technical Service Bulletin 84-7-13. Any one has any comment?
|
- #44 of 231
-
Re: 95 Bronco Transmission Problem [oldblue3]
by wjames
-
Jun 02, 2007 (5:54 am)
-
|
|
Replying to: oldblue3 (Mar 27, 2007 6:09 pm)
I have a 95 bronco and when the transmission get hot it won,t work. I have it at a transmissoin shop and he can,t figure it out any answers...
|
- #45 of 231
-
89 Bronco II engine problems
by silverback3
-
Jun 16, 2007 (3:03 pm)
-
|
I have an 89 Bronco II. After driving for about 15 minutes, the exhaust pops and starts to lose power. If I let it cool back down, it runs fine for 15 minutes (until it's heated back up).
I've had the ignition module checked, O2 sensor checked, new coil, new computer. Nothing seems to be fixing the problem. Any suggestions?
|