Sign In Join 



Ford Bronco Problems

231 messages,  Last post on Nov 21, 2009 at 2:24 AM

You are in the Ford Bronco Forum. Your Hosts are steve_ & tidester

What is this discussion about? Ford Bronco


Messages Page 5 of 24
1
2
3
4
5
6
7
8
...
24
Prev
Next
Last
Go To Msg #
Search This Discussion

#35 of 231
Re: Broken bolt on water pump [deacon2] by Mr_Shiftright HOST
Jan 10, 2007 (9:28 am)
Reply

Replying to: deacon2 (Jan 10, 2007 7:06 am)

Well good luck and just take your time and keep your sense of humor and you'll be fine with it. Don't rush or get frustrated.
#36 of 231
Re: Broken bolt on water pump [Mr_Shiftright] by deacon2
Jan 12, 2007 (6:30 am)
Reply

Replying to: Mr_Shiftright (Jan 10, 2007 9:28 am)

I went to Lowes and got a blackgold drill bit as well as a diamond grit drill bit. Figured I would give the blackgold a try since they say they are "stronger and sharper". They were the only place I could find the diamond grit drill bit. Here's to hoping.....
#37 of 231
Re: Broken bolt on water pump [deacon2] by Mr_Shiftright HOST
Jan 12, 2007 (8:41 am)
Reply

Replying to: deacon2 (Jan 12, 2007 6:30 am)

Do you have a stout metal punch to punch out a starter hole before you drill?
#38 of 231
Re: 93 Ford Bronco w/ throttle sensor problems [daveshir] by oldblue3
Mar 27, 2007 (5:46 pm)
Reply

Replying to: daveshir (Jul 08, 2006 9:17 am)

I have had a few dozen of these broncos the motor is probably the problem 4 the wipers your wiring problem is probably at the front of the bronco by the battery the wires always get pinched right there there is also a wire there that will effect the running condition of the truck and radio shack sells a nice wire cleaner 4 about 6.00 bucks a can
#39 of 231
Re: Broken bolt on water pump [Mr_Shiftright] by oldblue3
Mar 27, 2007 (5:48 pm)
Reply

Replying to: Mr_Shiftright (Jan 12, 2007 8:41 am)

yes spring loaded impact center punch available at any local car parts chain
#40 of 231
Re: Front End 93 eddie bauer 5.8 [devinque] by oldblue3
Mar 27, 2007 (5:52 pm)
Reply

Replying to: devinque (Sep 01, 2006 8:19 pm)

check your lower ball joints
#41 of 231
Re: 95 Bronco Transmission Problem [rpierce3] by oldblue3
Mar 27, 2007 (6:09 pm)
Reply

Replying to: rpierce3 (Sep 25, 2006 4:18 pm)

about 3.00 to4.00 hundred you can save some if you choose to pull it yourself yes a 4wd truck trans will work providing its close to your year and make sure to put in an extra trans cooler with an electric fan it will cost a little extra but well worth it these trannys are known for overheating and the cooler and fan will increase the life of the new one a lot hope i helped you and good luck
#42 of 231
95 ABS light by falcon8
Apr 03, 2007 (5:52 pm)
Reply
ABS light staying on.Checked relay and fuses.Not sure what resistance should be for sensors.Could I use a hand held code scanner to get codes, same one for ecm?
#43 of 231
85 Bronco Feedback Carburetor by art20
May 25, 2007 (4:53 pm)
Reply
I´m repairing YFA Carter Carburetor. There is a Sticker attached close to radiator that indicates that antidiesel screw must not be used to adjust idle speed and indicates to see Technical Service Bulletin 84-7-13. Any one has any comment?
#44 of 231
Re: 95 Bronco Transmission Problem [oldblue3] by wjames
Jun 02, 2007 (5:54 am)
Reply

Replying to: oldblue3 (Mar 27, 2007 6:09 pm)

I have a 95 bronco and when the transmission get hot it won,t work. I have it at a transmissoin shop and he can,t figure it out any answers...

Messages Page 5 of 24
1
2
3
4
5
6
7
8
...
24
Prev
Next
Last
Go To Msg #
Search This Discussion
To POST a message, please Sign In.

New? Join Now!

Forum Tools

Please sign in.
Email Address:

Password:

Forgot Password?

Search Forums

Enter Keyword(s)

Advanced Search

Browse by Vehicle



View All Vehicles
Advertisement
Ask the Community
See What People Are Asking

Browse by Board

Browse by Topic


View All Topics

Today's Chats

Advertisement