- #34 of 231
-
Re: Broken bolt on water pump [Mr_Shiftright]
by deacon2
-
Jan 10, 2007 (7:06 am)
-
|
|
Replying to: Mr_Shiftright (Jan 09, 2007 4:43 pm)
thank you
|
- #35 of 231
-
Re: Broken bolt on water pump [deacon2]
by Mr_Shiftright HOST
-
Jan 10, 2007 (9:28 am)
-
|
|
Replying to: deacon2 (Jan 10, 2007 7:06 am)
Well good luck and just take your time and keep your sense of humor and you'll be fine with it. Don't rush or get frustrated.
|
- #36 of 231
-
Re: Broken bolt on water pump [Mr_Shiftright]
by deacon2
-
Jan 12, 2007 (6:30 am)
-
|
|
Replying to: Mr_Shiftright (Jan 10, 2007 9:28 am)
I went to Lowes and got a blackgold drill bit as well as a diamond grit drill bit. Figured I would give the blackgold a try since they say they are "stronger and sharper". They were the only place I could find the diamond grit drill bit. Here's to hoping.....
|
- #37 of 231
-
Re: Broken bolt on water pump [deacon2]
by Mr_Shiftright HOST
-
Jan 12, 2007 (8:41 am)
-
|
|
Replying to: deacon2 (Jan 12, 2007 6:30 am)
Do you have a stout metal punch to punch out a starter hole before you drill?
|
- #38 of 231
-
Re: 93 Ford Bronco w/ throttle sensor problems [daveshir]
by oldblue3
-
Mar 27, 2007 (5:46 pm)
-
|
|
Replying to: daveshir (Jul 08, 2006 9:17 am)
I have had a few dozen of these broncos the motor is probably the problem 4 the wipers your wiring problem is probably at the front of the bronco by the battery the wires always get pinched right there there is also a wire there that will effect the running condition of the truck and radio shack sells a nice wire cleaner 4 about 6.00 bucks a can
|
- #39 of 231
-
Re: Broken bolt on water pump [Mr_Shiftright]
by oldblue3
-
Mar 27, 2007 (5:48 pm)
-
|
|
Replying to: Mr_Shiftright (Jan 12, 2007 8:41 am)
yes spring loaded impact center punch available at any local car parts chain
|
- #40 of 231
-
Re: Front End 93 eddie bauer 5.8 [devinque]
by oldblue3
-
Mar 27, 2007 (5:52 pm)
-
|
|
Replying to: devinque (Sep 01, 2006 8:19 pm)
check your lower ball joints
|
- #41 of 231
-
Re: 95 Bronco Transmission Problem [rpierce3]
by oldblue3
-
Mar 27, 2007 (6:09 pm)
-
|
|
Replying to: rpierce3 (Sep 25, 2006 4:18 pm)
about 3.00 to4.00 hundred you can save some if you choose to pull it yourself yes a 4wd truck trans will work providing its close to your year and make sure to put in an extra trans cooler with an electric fan it will cost a little extra but well worth it these trannys are known for overheating and the cooler and fan will increase the life of the new one a lot hope i helped you and good luck
|
- #42 of 231
-
95 ABS light
by falcon8
-
Apr 03, 2007 (5:52 pm)
-
|
|
ABS light staying on.Checked relay and fuses.Not sure what resistance should be for sensors.Could I use a hand held code scanner to get codes, same one for ecm?
|
- #43 of 231
-
85 Bronco Feedback Carburetor
by art20
-
May 25, 2007 (4:53 pm)
-
|
|
I´m repairing YFA Carter Carburetor. There is a Sticker attached close to radiator that indicates that antidiesel screw must not be used to adjust idle speed and indicates to see Technical Service Bulletin 84-7-13. Any one has any comment?
|
![[F]](http://a332.g.akamai.net/f/332/936/12h/www.edmunds.com/media/townhall/webxicons/site.gif){kind=small}
Forums
SUVs 
