Ask the Car People.SM


Ford Bronco Problems

350 messages,  Last post on Jul 05, 2009 at 8:53 PM

You are in the Ford Bronco Forum.

What is this discussion about? Ford Bronco

Messages Page 29 of 36

#275 of 350 88 Ford BroncoII issue. by caskeya

Feb 07, 2012 (2:22 am)

i tried getting out of a rut with my bronco, and my transmission fluid was drained entirely out of my vehicle, but it still turns over, and reves, but idk if its part of the transmission or just cause all the fluid dumped, but idk where to begin with looking. i looked under it and found some traces of trany fluid on the front axle. its a 2x4, so if anyone could tell me i need a new transmission or something less problematic. please reply.

#276 of 350 Re: 1992 Bronco not starting [krys5] by tclover

Feb 07, 2012 (6:13 pm)

Replying to: krys5 (Feb 06, 2012 2:20 pm)
I had a problem like this and it was the TPS sensor. The only difference is when I parked the Bronco it was bucking and would not idle without foot on gas.

#277 of 350 92 Bronco by black_beauty

Jun 14, 2012 (6:28 am)

V8 5.8 It was running just fine, i stopped to let a friend out of the bronco, put on reverse to back up and leave and when i shifted to drive again, rpm needle went to 0. fuel needle went from being half full to FULL..... then i noticed the acceleration was of, and if i hit throttle the rpms of the car would drop like if it was getting fuel congestion in the motor!! I HAVE NO CLUE WHATS WRONG... is it sensors. is it transmission. is it cables. or motor? ???? Can anyone help?

#278 of 350 85 Bronco 2.8L 6cyl Won't start just clicks by jenjohn007

Jun 16, 2012 (9:45 am)

Hey yall,
 
I've got an 85 Bronco 2.8L 6cyl 5 Speed. Engine runs like a champ. Got a starting problem.
 
It all started 2 days ago when my husband was driving it and said as he got to work, the radio stopped working, his gauges would not work, and neither would his blinkers. Went to his work, jump started him, drove to O'rielys and replaced the battery after 9 years (lol). Started right up then and there. We looked at the copper connections on the back of the alternator, saw they didn't have a great connection, so we put a bolt on the screw to ensure the connectors would stay on. The next day, my husband drove it again: started up right in the morning, he got off work, made 3 close range stops, made a 4th stop and needed a jump again. Again, he would try to start, but it only made a repetitive clicking noise. Jumped him, drove it home, and again, only clicking when trying to start. So we replaced the alternator and the voltage regulator, and still a clicking noise. We jumped it once again, but after about 10 minutes of just idling, I smelled burning plastic. Come to find out, the voltage regulator had a crack in the black plastic on the back and it was EXTREMELY hot to touch, only after 10 minutes. I'm not sure as where we need to look for a problem. It has 950k on it currently and the odometer has rolled over once already. It's definitely been worth the money spent so I'm trying to figure a solution before I get too frustrated and just trash it. My husband is a diesel mechanic so he can understand all the lingo. Any help would be appreciated! Thank you and have a great day!

#279 of 350 Ford Bronco electrical problems by cdcdarb

Mar 22, 2013 (7:52 pm)

#280 of 350 electrical problem by cdcdarb

Jun 15, 2008 (7:30 pm)

I have a 96 ford bronco, 5.8 automatic, runs and starts good, but when I turn on the headlights the engine dies, would seem to be a short, but does anyone know if it could be another known problem ?

#281 of 350 Re: electrical problem [cdcdarb] by tidester

Jun 15, 2008 (10:05 pm)

Replying to: cdcdarb (Jun 15, 2008 7:30 pm)
One thought that comes to mind is that it may be your alternator. It may not be producing enough electricity to power your engine with the headlights on. Anyone else have any ideas?
 
tidester, host
SUVs and Smart Shopper

#283 of 350 Ford Bronco 11 electrical problems by robb14u

Aug 22, 2008 (11:16 pm)

I've got an 85 eddie bauer with P/L , P/W, and C/C that have issues,, a short time ago the P/L stopped working, and the P/W are not going up as fast as they use to.. but still work.. and a couple days ago the C/C stopped working,, have hayne's repair man,, but doesn't say much in the elec, chapter.. and electric diagram sucks.. any ideas as to where the relays are located, or what else I should check, and where it is located?? thanks

#284 of 350 by ladybronco89

Sep 19, 2008 (9:57 am)

i have a 89 fullsize 5.8 liter and my left break lights and my turn signal on the same side dosen't work. I tryed the fuses and changing the bulb. What eles can i do?

Messages Page 29 of 36

To POST a message, please Sign In.

Advertisement

Browse by Category

Browse by Vehicle
   View All Vehicles

Browse by Board
Browse by Topic
View All Topics

Edmunds Community

Advertisement