You are here: Forums SUVs Ford Bronco Ford Bronco Problems

Ford Bronco Problems

231 messages,  Last post on Nov 21, 2009 at 2:24 AM

You are in the Ford Bronco Forum. Your Hosts are steve_ & tidester

What is this discussion about? Ford Bronco

Messages Page 23 of 24 1 ... 18 19 20 21 22 23 24 Prev Next Last

Go To Msg # Search This Discussion

#220 of 231 water temp sensor by jeversoll Nov 07, 2009 (1:10 am)
My daughters Bronco, the gauge doesnt work and am thinking that the sensor has gone south...   Where in gods green earth is it located!!! I have no probem finding the one on my Big Block Chevy!!! But can't seem to locate the fords sensor.. Please help me insted of going to the dealer and bending over!!!
#221 of 231 Re: 1996 bronco [96eddiebauer] by jeversoll Nov 07, 2009 (1:38 am)
Replying to: 96eddiebauer (Nov 06, 2009 3:24 pm) Hey there96 eddie..looks like a new switch is in order...   That is a fairly easy replacement
#223 of 231 Idel by jeversoll Nov 07, 2009 (1:48 am)
Daughters 86 Bronco Fuel injected has just started having a high idel   Any one out there have a clues as to what I should do John
#224 of 231 RPM gauge stopped work now it runs bad by 92bronconitetx Nov 09, 2009 (1:46 pm)
I have a 1992 EB 5.0 and the rpm gauge stopped working,now it will idle fine but if I give it gas it seems like it want to die,but doesnt. Any clues? Replies to this message: jeversoll (Nov 09, 2009 11:25 pm) 92bronconitetx (Nov 10, 2009 4:56 am) jeversoll (Nov 10, 2009 11:22 am) and 1 more...
#225 of 231 Re: RPM gauge stopped work now it runs bad [92bronconitetx] by jeversoll Nov 09, 2009 (11:25 pm)
Replying to: 92bronconitetx (Nov 09, 2009 1:46 pm) Have you checked the distributor cap for a crack??? try and replace the cap and rotor first that is the least expensive route. Then we can go on from there. John Replies to this message: 92bronconitetx (Nov 10, 2009 4:56 am) jeversoll (Nov 10, 2009 11:22 am) 92bronconitetx (Nov 10, 2009 11:38 am)
#226 of 231 Re: RPM gauge stopped work now it runs bad [jeversoll] by 92bronconitetx Nov 10, 2009 (4:56 am)
Replying to: jeversoll (Nov 09, 2009 11:25 pm) When the rpm gauge starts working the truck runs fine, could this still be related to the cap and rotor? Replies to this message: jeversoll (Nov 10, 2009 11:22 am) 92bronconitetx (Nov 10, 2009 11:38 am)
#227 of 231 Re: RPM gauge stopped work now it runs bad [92bronconitetx] by jeversoll Nov 10, 2009 (11:22 am)
Replying to: 92bronconitetx (Nov 10, 2009 4:56 am) In your msg you stated that when the rpms increased the engine would run bad, and I suggested to change the cap and rotor. I myself have done this and found a very small crack in the cap.if there is a crack in the cap the electricity will find it's way out of the cap caussing a disturbance in the flow to the other spark plug wires. If this doesn't workI am sorry But it didn't cost you $20.00 Replies to this message: 92bronconitetx (Nov 10, 2009 11:38 am)
#228 of 231 Re: RPM gauge stopped work now it runs bad [jeversoll] by 92bronconitetx Nov 10, 2009 (11:38 am)
Replying to: jeversoll (Nov 10, 2009 11:22 am) Only when the gauge doesn't work does the engine not perform properly, when my gauge is working I can drive it no problem. when the gauge is out if I try and exellerate it shudders and seems like it is going to die(but doesn't) I will try the cap and rotor tomorrow if you think it will help. Like you said 20 bucks no harm no foul.
#229 of 231 CUTS OUT by jeversoll Nov 15, 2009 (1:44 pm)
Hi guys!!!! I know that someone out theree in Bronco Land has had this problem....   My daughters Bronco cuts out after it has been running for ten minuets   on aceleration... We have replaced the coil thinking it was on the way out a fuel sensor thinking the same thing... and a host of other parts..   Does anyone have that magic answer before I go BROKE!!!!!!!!!!!!!!!!!!   Thanks John E. in Anaheim Ca

Messages Page 23 of 24 1 ... 18 19 20 21 22 23 24 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums SUVs Ford Bronco Ford Bronco Problems