Edmunds.com | Inside Line | Auto Observer Your Account | Help | Directory
You are here:
![[F]](http://a332.g.akamai.net/f/332/936/12h/www.edmunds.com/media/townhall/webxicons/site.gif){kind=small}
Forums
SUVs Ford Bronco Ford Bronco Problems
228 messages, Last post on Nov 10, 2009 at 11:38 AM
You are in the Ford Bronco Forum. Your Hosts are steve_ & tidester
|
Replying to: khawley (Mar 04, 2009 4:28 pm) On a side note to Redraider....the hercky jercky or "trailer-hitching" effect, as someone put it, turns out to be the torque converter in my tranny. Go figure...I knew my motor was running to smooth for something cheap and simple. HA. Thanks for all your help. Jutmac
|
|
|
|
|
Replying to: jutmac (Mar 04, 2009 4:52 pm) Glad you got it figured out. I had to think about that one and asked a buddy at work. I was going to say start with the simple things.....fuel addative to take care of any BAD GAS, fuel filter, etc. Next would be the speed sensor, or torque converter......one located on your tranny and the other on your differential. In any case, glad to help any time. |
|
| Anyone know what causes the pick up coils to go bad. I replaced the first one with a new one from auto zone. it started right up but didn't run 100% and lasted 2-3 weeks and let me set. I replaced it again with a new one from auto zone. This one started right up but ran poor, missed & cut out, the tach would also fall to zero when it was miss firing. It ran worse on a hard pull in overdrive. I was told to replace it with oem, I did and it ran great even in O.D. on hard pulls. it was in about 3 weeks and today it let my son set. When I try to start it the tach makes one jump and falls to zero staying there while cranking. I know if I replaced it again it would start right up, and while cranking the tach would go up to 200-300 rpm's before starting.Any ideas what keeps killing them? | |
| i ran it without exhaust mostly idoling for about 10 mints and it started to run ruff...i put on an exhaust and it still ran bad...it makes a popping noise on the left side of the motor not quite a back fire but like it's a dead miss...it does it when i give it gas to...like it's gettin choked out on 1 cylander...i think it might be a burnt valve but would like more opinions | |
|
|
94 Bronco 143K never any major problems, All of a sudden has a problem getting it started. Acted like it didn't want to start but after holding the gas pedal down it come to a shaky start.  After getting it going act like it wont acclerate, shakes almost like it getting no gas. That day began to run fine no more problems after driving around for about five minutes. Now it hard to start and has problem accelerating. It will only accelerate very very slowly then almost bog down if I press the gas down hard at all? I think it is some kind of fuel problem please help?
|
|
|
|
|
I OWN A 1984 FORD BRONCO AND I'M TRYING TO FIND LEGAL EXHAUST SYSTEM WITH HEADERS. I FOUND A LOT OF PLACES THAT SELL HEADERS THAT ARE NOT STREET LEGAL.EVERY PLACE THAT I CALLED SAY THAT NOBODY MAKES THEM. PLEASE HELP ME! |
|
|
Hi, need help in South Africa. We own a 1993 Ford Bronco. The electronic speedo has started giving problems. It sometimes works and then not. I have spoken to a couple of auto electricians here but they do not have an idea how to fix it, any suggestions? Have to do quite a far trip with it soon and really do have to fix it. PLEASE HELP! |
|
|
I'm having a lot of trouble putting together my E4OD from my '93 Bronco. Everything checks out and is put together right, but everytime I bolt in the front pump, the whole works locks up and won't turnover. It would seem that something must be up too high, but I can find nothing wrong. Has anyone else had this trouble? What am I doing wrong?
|
|
|
Replying to: 94broncohause (Mar 29, 2009 6:46 am) |
|
You are here:
Forums
SUVs Ford Bronco Ford Bronco Problems
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
1996 Ford Bronco
Browse by Board
Browse by Topic
Today's Chats
